Downloaded from www.vandenborre.be
hooks Placed on both sides of the cover.
• Change the light bulb with a new one (type E14 Base
15W)
• Replace the light cover and then reconnect the appliance
to the mains supply.
DOOR REVERSAL:
• Disconnect the appliance from the mains supply by removing the plug from the outlet.
• Remove the hole blanking cover from the top of the door were the top hinge is
positioned picture 1.
• Remove the top door hinge pin with a flat blade screwdriver by unscrewing it picture 1.
• Remove the top door by tilting the door slightly away from the hinge and lifting the
door to remove the door from the middle hinge.
• Place the door in a safe location so it does not get damaged.
• Remove the two screws from the middle hinge and remove the hinge picture 2 .
• Lift the bottom door from the bottom hinge pin.
• Place the bottom door in a safe location so it does not get damaged.
• Remove the door limiters from the bottom of both doors by removing the screws.
• Fit the new left hand door limiters supplied in the accessory bag on to the opposite
side of both doors picture 3.
• Remove the thermostat control knob from the front facia panel picture 4; remove the
front facia sticky cover to be able to gain access to the top hinge screws and remove
the screws. Remove the screws from the back of the top cover lift the top cover slightly
picture 5.
• Please ensure that the appliance is disconnected from the mains supply as there are
electrical components accessible when the refrigerators top cover is removed.
• Transfer the hinge blanking cover from one side of the top cover to the other side
picture 8-9.
• Remove the two screws from the top hinge and remove the hinge picture 6.
• Tilt the appliance back slightly to be able to gain access to the bottom hinge screws
(it is recommended to ask another person to help tile the appliance backwards) this
will enable you to remove the screws from the bottom hinge.
• Reposition the bottom hinge onto the other side of the refrigerator picture 7.
• Fit the bottom door back onto the bottom hinge pin and close the door.
• Fit the middle hinge onto the bottom door and fasten with the two screws picture 12.
• Refit the top hinge onto the other side of the top door with the hinge pin you removed
earlier and replace the hole blanking cover from the top of the door picture 13.
• Refit the top door onto the middle hinge and close the door inserting the top hinge into
its new location and fasten with the two screws.
• Replace the top cover and attach the new control panel cover supplied in the
accessory bag and replace the thermostat control knob picture 10 and 11.
• Transfer the door handles to the opposite side of the doors by removing the screw
covers covering the holes in the doors and fill the remaining holes with the plastic hole
covers supplied in the accessory bag picture 14.
• Ensure the doors are level and the door seals close correctly.
• Re position the appliance and re connect to the power supply outlet.
