Manual Proline PLC 235 (page 59 of 64) (English, German, Dutch, French, Italian)

453383

Zoom out

Zoom in

1/64

Downloaded from www.vandenborre.be

PART 4 Defrosting

REFRIGERATOR DEFROST PROCESS:

• The refrigerator defrost process is carried out automatically every time the compressor

stops.

• The defrost water drains from the cabinet into a tray placed on the top of the compressor to

the rear of the unit where it evaporates from the heat of the compressor. Make sure the

drain hole on the ridge at the back of the refrigerator compartment is kept clear.

Refrigerator Compartment

FREEZER DEFROST PROCESS:

• Over time frost will accumulate inside the freezer depending upon the length of time during

which the door is left open or the amount of moisture introduced.

It is essential to ensure that no frost or ice is allowed to form at places where it will affect the close

fitting of the door seal.

This might allow air to penetrate the cabinet, thus encouraging continuous

running of the compressor.

Thin frost formation is quite soft and can be removed with a brush or plastic scraper.

• For the removal of thin frost it is not necessary to switch off the appliance.

• For the removal of heavy ice deposits disconnect the appliance from the mains supply and

empty the contents into cardboard boxes and wrap in thick blankets or layers of paper to

keep them cold.

• Defrosting should be undertaken when the freezer is nearly empty, and it should be carried

out as quickly as possible to prevent undue increase in temperature of the contents.

• Providing that the contents are well wrapped and placed in a cool location they should keep

for several hours.

• Examine the contents when replacing them in the freezer and if some of the packages have

thawed out it should not be re frozen but eaten within 24hours or cooked and refrozen.

• This appliance is provided with a special drain system. Pull out the drain funnel which is stored

on the front of the freezer.

• unfold the rubber funnel as shown in the diagram below and place a container

to the front of the freezer to collect the drained water.

• After defrosting has finished clean the inside of the freezer with a solution of warm water

with a little bicarbonate of soda and then dried thoroughly.

Wash all removable parts in the same way and replace the funnel to it normal position.

• If there is still water on the freezer floor, you can clear it away by using a sponge.

• Reconnect the appliance to the main supply and turn the thermostat up to maximum.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Proline PLC 235 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,52 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Proline PLC 235 Manual

Product: