495822
14
Zoom out
Zoom in
Previous page
1/36
Next page
Downloaded from www.vandenborre.be
warm water with a little washing-up liquid
added.
Defrosting the freezer
Defrost the freezer when the frost layer rea-
ches a thickness of about 10-15 mm.
The best time to defrost the freezer when it
contains no or only a little food.
To remove the frost, do these steps:
1. Switch off the appliance.
2. Remove any stored food, wrap it in
several layers of newspaper and put it
in a cool place.
3. Leave the lid open , remove the plug
from the defrost water drain and collect
all defrost water on a tray. Use a scra-
per to remove ice quickly.
4. When defrosting is completed, dry the
interior thoroughly and refit the plug.
5. Switch on the appliance.
6. Set the temperature regulator to obtain
the maximum coldness and run the ap-
pliance for two or three hours using this
setting.
7. Reload the previously removed food in-
to the compartment.
Important! Never use sharp metal tools to
scrape off frost as you could damage the
appliance. Do not use a mechanical device
or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
The amount of frost on the walls of the ap-
pliance will be increased by the high level of
the outer environment humidity and if the
frozen food is not wrapped properly.
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance.
2. Disconnect the mains plug from the
mains socket.
3. Remove all food.
4. Defrost and clean the appliance and all
accessories.
5. Leave the lid open to prevent unpleas-
ant smells.
Important! If the cabinet will be kept on,
ask somebody to check it once in a while to
prevent the food inside from spoiling in
case of a power failure.
WHAT TO DO IF…
Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or compe-
tent person must do the troubleshoot-
ing that is not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem Possible cause Solution
The appliance is noisy The appliance is not supported
properly
Check if the appliance stands sta-
ble (all the four feet should be on
the floor)
The compressor oper-
ates continually
The temperature is not set cor-
rectly.
Set a warmer temperature
The lid has been opened too fre-
quently
Do not leave the lid open longer
than necessary
The lid is not closed properly Check if the lid closes well and
the gaskets are undamaged and
clean
Large quantities of food to be
frozen were put in at the same
time
Wait some hours and then check
the temperature again
Food placed in the appliance
was too warm
Allow food to cool to room tem-
perature before storing
14
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Proline PLC 102 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Proline PLC 102 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info