The barbecue can be operated with gas cylinders weighing between 5 kg and 15 kg. Low pressure butane, propane and LPG gas mixtures are approved.
Your barbecue works best with propane gas and LPG mixtures. Butane can be used, on account of the power rating of the appliance, the gas cylinder may
however freeze. As a result of this, the gas pressure drops and your barbecue does not provide full power.
Use a regulator which is certied in accordance with DIN EN 12864:2001.
NOTE:
For information concerning the correct regulator for gas cylinders, please consult your LPG dealer.
Regulator and hose
These parts are supplied with the barbecue. You can obtain spare parts from your dealer or an approved LPG supplier. Only use hoses and regulators at the
pressure stated above which are approved for LPG.
Normally, the service life of a regulator is 2 years. It is recommended that the regulator is replaced within 2 years of the production date.
WARNING:
• The hose that is used must correspond to statutory regulations.
• The use of unsuitable hoses and incorrect regulators is dangerous.
• Before operation, make sure that you use the correct parts.
Connecting the gas cylinder
A connection is established via a exible hose and the correct low pressure regulator. The low pressure regulator should be tted onto the gas cylinder.
1. Remove the protective cap and the thread protector on the gas cylinder.
2. Select a suitable wrench and tighten the coupling nut (attention: left thread) of the low pressure regulator on the gas cylinder hand-tight.
3. Select a suitable wrench and tighten the coupling nut (attention: left thread) of the hose on the low pressure regulator hand-tight.
Connecting the appliance
Spider’s webs and insects can block the burner or pipe. Before connecting, make sure that the burner and the burner ports are clean.
You will nd the gas connection on the left hand side of the appliance level with the adjustment knobs.
• Select a suitable wrench and tighten the coupling nut (attention: left thread) of the hose on the barbecue.
The screw connections of the hose must be securely connected to the appliance and the low pressure regulator.
Finding areas with a bad seal
CAUTION: Before use, check to make sure there are no areas with a bad seal.
• Never look for sections with a bad seal using a naked ame.
• Use a leak detection spray or soapy water.
Sections with a bad seal soon become apparent in soapy water. You will need approx. 50 ml (mix ratio 1:3).
1. Make sure that all adjustment knobs are in the 12 o’clock position (OFF).
2. Once you have connected all components as described above, turn the gas on.
3. Spread the soapy water on the hose and all connections. If bubbles appear at a particular point, the section has a bad seal and it must be repaired before
use.
4. Repeat the test after the repair.
5. After the test, shut the valve on the gas cylinder.
If you nd a section with a bad seal that you cannot repair, refer the problem to a gas technician
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for ProfiCook PC-GG 1059 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of ProfiCook PC-GG 1059 in the language / languages: English, German, French, Italian as an attachment in your email.
The manual is 7,53 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
