685738

ProfiCook KA 1138 Manual

38
Zoom out
Zoom in
Previous page
1/50
Next page
38
PC-KA1138_IM_new 11.09.2017
Stop Operation
1. Press the button to switch off the appliance. (Standby mode)
2. Unplug the power cord from the wall outlet.
3. Clean the appliance after each use.
De-scaling
De-scaling is necessary when the brewing time increases substantially.
• Use only commercially available citrus acidbased de-scaler.
• Follow the recommended instructions for use.
• Use the button to select the function and “non-keep warm”.
WARNING:
• Afterwards you should boil fresh water in the pot three or four times
in order to rinse out residues of the descaling agent.
• Do not use any coffee powder!
• Do not use this water for consumption.
Cleaning
WARNING:
• Before cleaning, always remove the mains plug and
wait until the appliance has cooled down.
• Do not immerse the appliance in water. Otherwise
this might result in an electric shock or re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The exterior of the appliance should be cleaned as necessary with a
slightly damp cloth – without any additives.
• The coffee pot and the lter pad should be cleaned by rinsing in warm
water. Use a soft brush if necessary.
Filter Holder Insert
Please refer to gure C on page 5.
• Wipe the lter holder insert with a paper towel after each use.
• Remove the coffee powder residue with a cleaning brush.
Maintenance of the Grinder
Maintain the grinder on a weekly basis. Refer to gures D to H on page 5.
NOTE:
Empty the coffee bean container best by using all beans for the coffee
preparation.
1. Insert the lter holder with a new lter bag into the coffee machine to
catch the remaining coffee powder. Alternatively, you can place a dry
container onto the hot plate.
2. Press the button to switch off the appliance.
3. Press and hold the button until the control light next to “clean”
ashes. After a few seconds, the grinder will turn briey and unlock.
The remaining coffee powder falls out. The display shows .
4. Unplug the power cord.
5. Open the coffee bean container.
6. Rotate the lock part of the grinder clockwise to open. Take it off. (Fig. D)
7. Turn the regulator of the coarseness level clockwise to the coarsest
level (Fig. E a)
8. Press down on the coarseness level indicator and turn the regulator
clockwise, until the indicator points to the red dot. (Fig. E b)
CAUTION:
Do not try to turn the regulator by force! Reinsert the grinder cap
and repeat steps 1 - 8 until the regulator turns. If the regulator is
completely blocked, hand in your coffee machine for repair.
9. Pull out the upper grinding cone. (Fig. E c)
10.
WARNING: Risk of injury!
The blades of the cone are sharp.
11. Carefully clean the upper grinding cone with a cleaning brush and a
dry cloth.
12. Carefully clean the grinder tunnel with a cleaning brush. (Fig. F a)
13. Take a vacuum for help. Place the suction hose over the open grinder
and vacuum out the residues. (Fig. F b)
14. Vacuum the grinder tunnel from below. (Fig. F c)
15. Re-insert the cleaned upper grinding cone. Please make sure that the
bar of the grinding cone is in line with the symbol (Fig. G)
16. Turn the knob of the grinder counter-clockwise over coarseness
setting 1, until it audibly unlocks.
17. Insert the grinder cap and turn it clockwise. It must audibly lock in.
(Fig. H)
Storage
• Clean the appliance as described and let it dry completely.
• For longer periods of non-use we recommend storing the appliance in
its original packaging.
• Always store the appliance in a well-ventilated and dry place out of
reach of children.
Troubleshooting
Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:
Problem Possible cause Notes / Solution
The appliance does not work. The appliance is not connected to mains power. Check the wall outlet with a different appliance.
Insert the plug properly in the wall outlet.
Check the fuse.
The appliance is defective. Contact our service or a repair center.
Filter blockage: coffee grounds
spill over the edge of the lter.
The drip stop is closed: The coffee pot is not on the
warming plate or the lid is not on the coffee pot.
1. Switch the appliance off. Disconnect from mains
power supply.
2. Put the coffee pot with lid on the warming plate so
that the lter is emptied.
3. Dispose of the paper lter.
4. Clean the appliance as described.
Too much coffee powder in the lter.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ProfiCook KA 1138 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ProfiCook KA 1138 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 3,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info