807258

Pro-User TPMS2 Manual

7
Zoom out
Zoom in
Previous page
1/44
Next page
7
Changing the Measurement Unit directly
1. Enter the Settings Mode by pressing the SET button for 3 seconds
(the LEARNING icon is flashing)
2. Press the RIGHT button (the SETTINGS icon is flashing)
3. Press the LEFT Button to enter the settings
4. Press the RIGHT Button 3x to go directly to the PRESSURE UNIT settings
(the “Bar” or “Psi” unit is flashing)
5. Press the LEFT Button to change the unit
6. Exit the settings menu by pressing 2x SET.
5. Sensor linking
If you have to exchange a sensor or a sensor is not correctly linked to the main unit (“Err”
is displayed or no data is shown), you need to relink the tyre sensors to the main unit to
work properly.
Note: After 20 seconds idle, the main unit will exit the settings mode. Please read the
following steps first and prepare your workplace. If you exceeded the time limit you have
to start over again.
1. Disassemble the sensors, remove the batteries as described in section 3 and
prepare your workplace.
2. Enter the Settings Mode by pressing the SET button for 3 seconds
(the LEARNING icon is flashing)
3. Press 1x LEFT button -> tyre A on the main unit´s display is flashing. Put the
CR1632 (+ plus facing upwards) battery into sensor A
4. Wait for the beep signal -> code learning was successful
5. Press the RIGHT button -> tyre B on the main unit´s display is flashing
6. Put the CR1632 battery into sensor B
7. Wait for the beep signal -> code learning was successful
Only for TPMS4: Repeat step 5-7 for tyre C and tyre D
8. Exit the settings menu by pressing 2x SET.
6. Testing the device
Driving Test: When driving faster than 20 km/h the sensors should activate
automatically no later than after 10 minutes and refresh the pressure values about every
120 seconds. Check the tyre pressure again for any pressure drop and the displayed
sensor data for plausibility.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-User TPMS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-User TPMS2 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 4.83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info