553939
23
Zoom out
Zoom in
Previous page
1/28
Next page
23
HOW TO MAINTAIN THE EXERCISE BIKE
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, the drive belt
may need to be adjusted.
See the EXPLODED DRAWING on page 27 to identify
the parts mentioned below.
To adjust the Drive Belt (66), first press the power
switch to the off position and unplug the power
cord.
Use a flat screwdriver and remove the Upper Shield
(10) and the right Shield Cover (13).
Next, remove the #8 x 32 x 13mm Screw (88) from the
Right Shield (12). Then, remove the #8 x 3/4" Screw
(94) from the Left Shield (11).
Then, use a socket set to remove the two 1/4" Flange
Nuts (99) from the Right Shield (12).
Remove the two #8 x 1/2" Screws (95) on the right
side of the Electronics Shield (98). Then, gently move
the Right Shield (12) away from the exercise bike.
Locate the Idler Pulley (37). Loosen the 3/8" Jam Nut
(71). Then, tighten the Idler Adjustment Screw (39)
until the Drive Belt (66) is tight.
When the Drive Belt (66) is tight, tighten the 3/8" Jam
Nut (71).
Reattach the Right Shield (12) with the #8 x 1/2”
Screws (95), the 1/4" Flange Nuts (99), the #8 x 3/4"
Screw (94), and the #8 x 32 x 13mm Screw (88).
Then, reattach the Upper Shield (10) and the right
Shield Cover (13).
MAINTENANCE AND TROUBLESHOOTING
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from the circuit to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this equipment.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-form LE DE TOUR FRANCE BIKE - PFEX19810 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-form LE DE TOUR FRANCE BIKE - PFEX19810 in the language / languages: English as an attachment in your email.

The manual is 1,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info