553943
12
Zoom out
Zoom in
Previous page
1/36
Next page
12
HOW TO TURN ON THE POWER
P
lug in the power cord
(see page 10). Next, locate
t
he on/off switch near the
power cord. Make sure that
the switch is in the “on” po-
sition.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing on page 11),
and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment,
the matrix and the display will light.
Test the clip by
carefully taking a few steps backward until the key
is pulled from the console. If the key is not pulled
from the console, adjust the position of the clip as
needed.
HOW TO USE THE MANUAL MODE
Insert the key into the console.
See HOW TO TURN ON THE POWER above.
Select the manual mode.
Each time the key is in-
serted, the manual
mode will be selected.
If you have selected a
program, reselect the
manual mode by
pressing any program
button twice; a track
will appear in the
matrix.
Start the walking belt.
To start the walking belt, press the Start button,
the Speed increase button, or one of the num
-
bered speed buttons.
If you press the Start button or the Speed in
-
crease button, the walking belt will begin to move
at 2 Km/h.
As you exercise, change the speed of
the walking belt as desired by pressing the Speed
increase and decrease buttons. Each time a but-
ton is pressed, the speed setting will change by
0.1 Km/h; if a button is held down, the speed set-
ting will change in increments of 0.5 Km/h. Note:
A
fter the buttons are pressed, it may take a moment
for the walking belt to reach the selected speed set-
t
ing.
If you press one of the numbered speed buttons,
the walking belt will gradually increase in speed
until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. To
restart the walking belt, press the Start button, the
Speed increase button, or one of the numbered
buttons.
Note: The first time the treadmill is used, observe
the alignment of the walking belt, and center the
walking belt if necessary (see page 27).
Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline increase and decrease buttons. Each time
a button is pressed, the incline will change by
0.5%. Note: After the buttons are pressed, it may
take a moment for the treadmill to reach the se-
lected incline setting.
Follow your progress with the matrix and the
display.
When the manual mode
is selected, the matrix
will show a track that
represents 400 meters
(1/4 mile). As you walk
or run on the treadmill,
the indicators around
the track will appear in
succession until the en-
tire track appears. The track will then disappear
and the indicators will again begin to appear in
succession.
The lower left corner of
the display will show the
approximate number of
calories you have
burned and the incline
level of the treadmill.
When you use the handgrip pulse sensor or the
chest pulse sensor, the lower left corner of the dis-
play will also show your heart rate.
5
4
3
2
1
On
Position
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pro-form 500 CX - PETL41106 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pro-form 500 CX - PETL41106 in the language / languages: English as an attachment in your email.

The manual is 3,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pro-form 500 CX - PETL41106

Pro-form 500 CX - PETL41106 User Manual - German - 36 pages

Pro-form 500 CX - PETL41106 User Manual - Dutch - 36 pages

Pro-form 500 CX - PETL41106 User Manual - French - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info