9
QUICK-CHARGE
In order to get a cordless shave quickly, place this shaver in its charging base for 10 minutes. This
allow you to shave immediately, for up to 3 minutes.
SHAVING
1. Remove the foil guard. Release the travel look switch, then slide the ON/OFF switch up to the ON
position.
2. Slowly guide the shaver upwards with the foil surface and the beard comb at a right angle to the skin.
Stretch the skin with your fingers and press the shaver lightly against the skin for a clean, close shave.
3. The cutting system consists of a beard comb and a unique row of vertical combing slots, which
enable you to shave a beard that is long or curled at the tips.
NOTE: The washable foil shaver cutting system is designed to be used as directed above. The cutting
performance of the shaver will be lessened if the shaver is not guided in an UPWARD direction.
NOTE: ALWAYS RINSE THE SHAVER THOROUGHLY IN LUKEWARM WATER AFTER SHAVING. See
cleaning instructions.
CAUTION: Too much pressure can cause skin damage. Use care to shave lightly when shaving without
soap or shaving cream.
4. After use, slide the ON/OFF switch down to the OFF position and replace the foil guard.
USING THE TRIMMER
1. Make sure the foil guard is properly attached
before using the trimmer.
2. Slide the ON/OFF switch up to ON position to
expose the trimmer.
3. To use the trimmer; press the trimmer gently
against your skin at a right angle, and trim slowly.
4. After use, slide the ON/OFF switch to the OFF
position, then retract the trimmer to its original position.
USER CLEANING & MAINTENANCE INSTRUCTIONS
• Your shaver has no user serviceable parts except the blade and the charging base.
• The shaver should be cleaned every 2-3 days.
• Accumulation of cuttings within the foil holder will reduce the cutting efficiency and cause cuttings
to scatter through the foil.
• The shaver is equipped with a interlock switch. Unless the interlock switch is engaged, the cutter
will not rotate, even if you remove the foil and slide the ON/OFF switch up to the ON position.
WASH YOUR SHAVER IN WATER
1. Always remove shaver from the charging base before cleaning.
2. Slide the ON/OFF switch down to the OFF position, then remove
the foil holder while keeping the removal buttons pressed.
3. Attach the rotary washer with the brush side of the rotary washer
to the back side of the shaver.
CAUTION: Make sure that the rotary washer is properly attached.
4. Wash the cutter with the ON/OFF switch in the ON position.
WARNING: DO NOT USE HOT WATER TO CLEAN SHAVER.
(Doing so may result in distortion or malfunction of the unit.)
5. Rinse in lukewarm water for approximately 10 seconds.
6. Slide the ON/OFF switch down to the OFF position, remove the
rotary washer, and wash the cutter holder and foil.
NOTE: Clean the shaver with a brush once every five times it is washed
in water.
NOTE: The body is watertight so that it can be washed in water.
CAUTION: Do not wash the charging base.
7. Wipe water drops off the body surface and dry the body of the shaver.
Remove the foil holder to quicken drying time.
8. Do not dry in a place exposed directly to sunlight or in a hot place.
9. Attach the foil holder.
