722002

Pride Sundancer Manual

26
Zoom out
Zoom in
Previous page
1/30
Next page
26 Sundancer
ASSEMBLY
1. Place the freewheel lever in the drive (down) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position and insert the longer tube of the front end into the rear section first;
make sure that the locking cam levers are vertically positioned and the locking pins are removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with ball detent pins.
6. Ensure the tiller is in an upright position.
7. Push the locking cam levers back to their locked (down) position.
8. Clip the front basket onto the front of the tiller.
9. If you removed the utility tray from the rear component, replace the tray by aligning the reusable fasteners on
the utility tray with those on your Scooters rear component; gently press down on the utility tray to ensure it is
secure.
10. Plug the large, white front-to-rear connector from the front section of your Sundancer into the mating plug
found on the control module cover on the utility tray at the rear of your Sundancer. The two orange dots
present on both plugs should be adjacent to each other and enable quick plug mating.
11. Put the batteries in place and plug the 2-pin battery harnesses into the adjoining harnesses that are also located
on the control module. Reconnect the battery tie-down straps.
12. If you removed the utility tray from the rear component, connect the 6-pin motor harness plug.
13. Gently place the rear shroud over the seat pedestal.
14. Connect the rear light harness, if so equipped. Make sure that the rear plastic shroud does not make any
contact with the rear wheels.
15. Slide the shroud down in place.
16. Carefully lift the seat and slide the small seat post (on the seat bottom) into the seat post tower.
17. Rotate the seat until it locks into place.
VIII. DISASSEMBLY AND ASSEMBLY
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Sundancer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Sundancer in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info