721999
37
Zoom out
Zoom in
Previous page
1/42
Next page
37
Hurricane
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your Hurricane are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below
develops.
NOTE: Your Hurricane will not run unless the flash code condition is resolved and the Hurricane has been
turned off, then turned back on.
What if all the systems on my Hurricane seem to be dead?
n Make certain that the key is in the on position.
n Check that the batteries are fully charged. See V. Batteries and Charging.
n Push in the main circuit breaker reset button. See IV. Your Hurricane.
n Make certain that both battery harnesses are firmly connected to the electronics module and to the battery
terminals. See VIII. Disassembly and Assembly.
n Make sure that the silver front-to-rear harness is firmly connected to the electronics module. See VIII.
Disassembly and Assembly.
n Be sure the auto shutoff feature hasnt been activated. See V. Batteries and Charging.
n Check the fuses. See XI. Care and Maintenance for fuse replacement.
What if the motor runs but my Hurricane does not move?
n With the key turned to the on position, check the status LED. If the LED flashes three times, pauses briefly,
then flashes twice, this is the manual freewheel lever code meaning your Hurricane is in freewheel mode. See
table above
n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the transaxle is cut.
n Push down the manual freewheel lever to restore normal operation to your Hurricane. See IV. Your Hurricane.
X. BASIC TROUBLESHOOTING
FLASH CODE CONDITION SOLUTION
Batteries are too low to operate the
scooter or the charger is operating.
Charge batteries or unplug the charger power
lead from the electrical outlet.
Controller is hot; the scooter seems to
be losing power.
Shut down your scooter for a minimum of
several minutes to allow the controller to
cool.
Wigwag fault; your throttle control
lever is not responding.
Call your authorised Pride provider for
assistance.
The manual freewheel lever is in the
(up) freewheel position.
Turn the scooter key to the off position, then
push the manual freewheel lever to the
(down) drive position: restart your scooter.
The scooter is operating with the
charger attached.
Unplug the charger lead from the charger
power lead receptacle.
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Hurricane at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Hurricane in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info