721999

Pride Hurricane Manual

35
Zoom out
Zoom in
Previous page
1/42
Next page
35
Hurricane
VIII. DISASSEMBLY AND ASSEMBLY
11. Remove the docking device ball detent pin.
See figure 27.
12. Gently slide the two sections of the Hurricane apart.
See figure 28.
FIGURE 28. FRAME SEPARATION
13. Grab the handle grip on the tiller, pull upward on the tiller adjustment lever, and gently lower the tiller down to
the center of the Hurricane chassis until it is fully lowered.
FIGURE 27. BALL DETENT PIN
NOTE: There is no need to disconnect the motor harness when
disassembling the Hurricane. See figure 29.
ASSEMBLY
NOTE: Raise the tiller before starting to assemble the Hurricane.
1. Place the manual freewheel lever in the drive (down) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position and insert the longer tube of
the front end into the rear section first; make sure that the locking
cam levers are in the unlocked (vertical) position and the ball detent pins are removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with the ball detent pins.
6. Push the frame lock levers back to their locked (downward) position.
7. Replace the ball detent pin into the docking device.
8. Plug the silver front-to-rear harness into the mating plug found on the electronics module.
9. Put the batteries in place and plug the black and white 2-pin battery harnesses into the electronics module.
10. Reconnect the battery tie-down strap.
11. Reconnect the handbrake cable by sliding the cable into its slot on the brake mount. With your thumb, push
forward and hold the brake release lever, then slide the cable release hook onto the peg and gently let go of the
brake release lever.
12. Gently place the rear shroud over the seat post.
13. Lower the shroud into place.
14. Carefully lift the seat and slide the seat platform (on the seat bottom) onto the seat pedestal.
15. Rotate the seat until it locks into place.
FIGURE 29. MOTOR HARNESS
BALL DETENT PIN
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Hurricane at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Hurricane in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info