668252

Pride Go-Chair Manual

15
Zoom out
Zoom in
Previous page
1/32
Next page
15
1
2
Controller Position
You can position the controller for either left-hand or
right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To change the controller position:
1. Turn off the power to the controller.
2. Cut the wire tie(s) securing the controller harness
to the armrest.
3. Flip up the armrest and loosen the setscrew. See
fi gure 11.
4. Slide the controller out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the controller in the other armrest.
7. Tighten the setscrew to secure the controller.
8. Use a wire tie to secure the controller harness to
the armrest, ensuring the armrest can freely be
raised and lowered without any tension on the
harness so they do not become disconnected.
9. Plug the controller connector into the power base.
Under-seat Storage
To operate under-seat storage
1. Lift up slightly on the latch on the side of the
under-seat storage bin (See fi gure 12) and swing
the under-seat storage bin out and away from the
travel chair.
2. To close the under-seat storage bin, push the
under-seat storage bin toward the center of the
travel chair until you hear the latch engage.
WARNING! Ensure both under-seat
storage bins are latched prior to
operating your travel chair.
To remove the under-seat storage
1. Lift up slightly on the latch on the side of the
under-seat storage bin (See fi gure 12) and swing
the under-seat storage bin out and away from the
travel chair until it is fully open.
2. Lift the under-seat storage bin up and off the
travel chair.
To install the under-seat storage
1. Align the slot on the under-seat storage bin over
the securement post.
2. Lower the under-seat storage pin onto the
securement post and push the under-seat
storage bin toward the center of the travel chair
until you hear the latch engage.
Figure 11. Controller Position
Figure 12. Under-seat Storage
Identifi cation Key
Identifi cation Key
1. Setscrew
1. Latch
2. Securement Post
1
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Go-Chair at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Go-Chair in the language / languages: English as an attachment in your email.

The manual is 7,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pride Go-Chair

Pride Go-Chair User Manual - Dutch - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info