722005
21
Zoom out
Zoom in
Previous page
1/44
Next page
21
Mid-size Scooter Series
III. BATTERIES AND CHARGING
10. Reconnect the battery harnesses.
11. Reconnect the battery tie-down strap.
12. Reinstall the battery shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact
your local waste disposal agency or your authorized Provider for instructions on disposal and battery
recycling, which is our recommended course of action.
2
1
1
To change batteries in your scooter:
1. Remove the seat and battery shroud. See figure
10.
2. Disconnect the battery tie-down strap. See
figure 11.
3. Disconnect the battery harnesses by depressing
the tabs on the battery harness connectors and
pulling them straight up. See figure 11.
4. Disconnect the battery cables from the battery
terminals by sliding back the terminal boots and
unscrewing the nut from the bolt. See figure 12.
5. Remove the old batteries from the battery wells.
6. Place a new battery in each battery well. Face the
battery terminals of each battery opposite each
other and toward the outer sides of the scooter. See
figure 11.
7. Connect the red battery cable to the positive (+)
battery terminal on each battery.
8. Connect the black battery cable to the negative (-)
battery terminal on each battery.
9. Reposition the terminal boots over the battery
terminals.
Figure 10. Battery Shroud Removal/Installation
*MODEL 104 ONLY
You may need the following to change your batteries:
Metric/standard socket set and ratchet
Adjustable wrench
WARNING! Do not lift beyond your physical capability. Ask for assistance when
necessary while disassembling or assembling your scooter.
WARNING! Do not pull on electrical harness wires directly to detach them from the
scooter. Always grasp the connector itself when disconnecting the harness to prevent
wire damage.
21


Need help? Post your question in this forum.

Forumrules
1

Forum

pride-colt-deluxe-2.0

Reset search

  • I bought a 'new' Pride Colt Deluxe 2.0. Later I discovered that both Track Rods where they fit on the Track Rod Ends as best as I could see has some play in them. I rang up the Shop who supplied it, & they sent someone out with a Tie Rap, & then put one on each of them to hold them firmly together. My question is, is this standard procedure when dealing with Mobility Scooters, or are they manufactured 'disabled' to be like the Owner ? Submitted on 3-10-2024 at 20:35

    Reply Report abuse
  • Console shows three green lights are out while charger is flashing fully charged Submitted on 15-10-2023 at 15:01

    Reply Report abuse
  • How do I enable the scooter to go from pushing to driving mode? Submitted on 1-7-2023 at 19:42

    Reply Report abuse
  • Why is my suspension on my pride deluxe Colt so tight Submitted on 21-9-2021 at 11:28

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pride Colt Deluxe 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pride Colt Deluxe 2.0 in the language / languages: English as an attachment in your email.

The manual is 2,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info