604329
68
Zoom out
Zoom in
Previous page
1/87
Next page
Assembling the Equipment
7
Attaching the Handrail Assembly
The handrail assembly arrives with four cables already installed. The base unit
data cable is rolled up and tucked inside the left tube. Before attaching the
handrail assembly, unroll the cable and remove the kinks.
To attach the handrail assembly:
1. Ask your assistant to hold the handrail assembly while you feed the base unit
data cable inside and completely down the left upright support.
Note: Make sure the cable connector rests on the floor at the base of the
upright support.
CAUTION: Be aware of the handrail extensions when you are working around the
front of the unit. It is easy to bump your head or sustain other injuries if you ignore
the location of the handrail extensions.
Figure 7: Feed cable from handrail extension through upright support
2. Ask your assistant to hold the handrail assembly above the upright supports.
Tip the assembly forward so the mounting brackets slide along the interior
rails inside the upright supports. Align the mounting holes and secure the
handrail using six ⁵₁₆-inch x ³₄-inch buttonhead cap screws and six split
washers. Partially tighten the fasteners.
Important: Make sure the fasteners do not pinch the cable. Cables damaged by
improper installation will not be covered by the Precor Limited Warranty.
Note: Thread the bottom hole first on either side. This will help line up the
other holes.
Figure 8: Handrail attachment
3. Pull the cable connector through the large hole in the left upright support and
attach it to the data port on the base unit frame.
Note: You will hear a click when it is fully connected.
Figure 9: Cable connection to lower board
68


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor TRM 425 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor TRM 425 in the language / languages: English as an attachment in your email.

The manual is 7,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info