575664
70
Zoom out
Zoom in
Previous page
1/83
Next page
Attaching the Console
9
Attaching the Console
Remove the display console from its box and protective packaging. Cut any wire
ties that secure the cables to the center handrail.
To attach the display console:
1. Ask your assistant to hold the display console above its mounting bracket
while you connect the cables to their appropriate receptacles on the back of
the display console.
Note: Each connector contains a tab that helps you align it properly.
Figure 10: Console cable attachments
2. Secure the cables under the clips in the indented area on the back of the
display console and lower the display console onto its bracket.
Important: Make sure that the cables are tucked into the cable clips before you
place the console on the bracket.
Figure 11: Cable clip locations
3. Feed excess cable into the center handrail.
4. Set the console onto the console bracket. It should sit flush on the console
without gaps. If there is a gap, check to make sure that now wires are being
pinched.
5. Align the four mounting holes with the back of the display console and
secure it using four M6 x 15 mm buttonhead screws and four
6.5 mm washers. Fully tighten the fasteners using a 4 mm hex key.
Figure 12: Console attachment
70


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor TRM 211 TREADMILL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor TRM 211 TREADMILL in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info