575664
69
Zoom out
Zoom in
Previous page
1/83
Next page
Treadmill 211 Assembly Guide 8
Attaching the Handrail Assembly
The handrail assembly arrives with cables already threaded inside of it.
Before attaching the handrail assembly, remove any kinks in the cable.
To attach the handrail assembly:
1. Ask your assistant to hold the handrail assembly while you connect the base
unit data cable between the left base support and the left side of the handrail
assembly.
Figure 8: Base unit data cable attachment
2. Have your assistant lower the handrail assembly onto the upright supports.
Tip the assembly slightly forward so the lip of each handrail cap rests on each
upright support. Align the mounting holes and insert six M8 x 15 mm
buttonhead screws and six 8.4 mm washers. Partially tighten the fasteners.
Important: Make sure the fasteners do not pinch the cable. Cables damaged by
improper installation will not be covered by the Precor Limited Warranty.
Figure 9: Handrail assembly
Tightening the Fasteners
Tighten the base screws in the order presented below.
To tighten the base fasteners:
1. Use a 5 mm hex key to alternately tighten the four front upright screws.
2. Use the 6 mm T-handle hex wrench to fully tighten the four socket head
screws through the sides of the upright supports.
3. Use the 5 mm hex key to fully tighten the six screws that secure the handrail
assembly to the upright supports.
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor TRM 211 TREADMILL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor TRM 211 TREADMILL in the language / languages: English as an attachment in your email.

The manual is 5,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info