604355
9
Zoom out
Zoom in
Previous page
1/108
Next page
536i Elliptical Fitness CrossTrainer Assembly Guide 7
CAUTION: Avoid cross-threading. Make sure the moving arm
assembly is well-aligned with the pivot tube before wrench
tightening. Any damage caused during installation is not
covered by the Precor Limited Warranty.
Attach one moving arm assembly at a time. Align and thread it
carefully into the pivot tube. To secure it, use a ½-inch open
end wrench and tighten the moving arm pivot joint. Guide the
moving arm to its equilibrium point and let it rest there.
Perform the same step for the opposite side.
Attach the lower link arms onto the moving handlebars using
two joint connector screws (H), two star washers (K), and two
joint connector nuts (J). Perform this step on one handlebar at
a time. Wrench tighten using a 5mm hex key.
Important: Be aware of the handlebar locations during
assembly. When assembling the lower link arms, position
yourself at the front of the EFX.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 536I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 536I in the language / languages: English as an attachment in your email.

The manual is 7,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info