604306
76
Zoom out
Zoom in
Previous page
1/91
Next page
Assembling the Equipment
15
Attaching the Console Bracket
Pull the cables out of the bracket and remove any kinks.
To attach the console bracket:
1. Feed the cable through the console bracket as shown in the following figure.
Figure 27: Feed cable through console bracket
2. Raise the console bracket onto the upper portion of the stabilizers.
3. Insert the two top ₁₆-inch x ³₄-inch hex head screws and ₁₆-inch washers.
Figure 28: Tightening the fasteners
4. Insert the four ⁵₁₆-inch x ³₄-inch hex head screws and four ₁₆-inch washers
into the side mounts and partially tighten them.
Figure 29: Console bracket attachment
5. Insert the two rear ⁵₁₆-inch x ³₄-inch hex head screws and four ⁵₁₆-inch
washers and fully tighten the fasteners.
Note: Perform this step to properly align the other screws in the console
bracket.
Figure 30: Rear screw location
76


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 423 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 423 in the language / languages: English as an attachment in your email.

The manual is 9,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info