604306
74
Zoom out
Zoom in
Previous page
1/91
Next page
Assembling the Equipment
13
Attaching the Stabilizers (EFX 447 and 425
Models Only)
This procedure applies to EFX 447 and 425 models only.
To attach the stabilizers:
1. Insert a clamp into each stabilizer and secure it loosely with two
buttonhead screws.
Figure 22: Location of clamp in stabilizer
2. Screw an adjustable foot into each stabilizer.
Note: Make sure the nut rests against the stabilizer.
Figure 23: Adjustable foot attachment
3. For easier access to the base mounts, lift the front of the EFX off the floor
and place a wedge of packaging cardboard beneath its base.
Figure 24: Wedge packaging beneath base frame
4. Have your assistant hold the stabilizer (with a cable protruding from both
ends) next to the movable arm assembly and base frame while you connect
the base cable. You will hear a click when the cable is properly attached.
Store excess cable in the stabilizer frame.
Figure 25: Base cable connection
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 423 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 423 in the language / languages: English as an attachment in your email.

The manual is 9,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info