604302
72
Zoom out
Zoom in
Previous page
1/83
Next page
Completing the Assembly
11
Completing the Assembly
CAUTION: The location of the On/Off switch is beneath the cutout on the base frame.
Make sure the power switch is in the Off position. Make sure the power cord is
disconnected from its power source.
Connecting the Power Cord
CAUTION: Use the supplied power cord. Do not remove or otherwise bypass the
3-prong plug with an adapter in order to use a nongrounded outlet. Do not plug the EFX
into a power transformer in an attempt to adjust the voltage requirements. Failure to
follow these instructions might damage the unit and will void the Precor Limited
Warranty. If an appropriate cord for your location was not included with your EFX,
please contact your Precor dealer for the proper Precor power cord. For more
information on authorized Precor dealers in your area, please contact Customer
Support at www.Precor.com.
To connect the power cord:
1. Insert the power plug connector into its receptacle at the rear of the unit.
Figure 22: Plug location
2. Plug the other end into a grounded outlet so you can maintain a consistent
power source without overloading any other circuitry. Be sure to use the
appropriate voltage. Refer to Grounding Instructions in the Owner’s Manual.
3. Use the power switch to turn the unit on. Check that the Precor banner
appears on the display. If the display remains blank, recycle the power. If the
display continues to remain blank, check the cable connections.
Leveling the EFX
Make sure the unit is level before allowing anyone to use it.
CAUTION: To eliminate movement, make sure the adjustable feet are in contact with
the floor.
To level the unit:
1. Gently rock the unit. If there is any movement, ask your assistant to tip the
unit to one side while you locate the adjustable feet.
Figure 23: Leveling the EFX
2. Correct the height of each adjustable foot as follows.
If you want to …
Then turn the adjustable feet …
Raise the unit Counterclockwise
Lower the unit Clockwise
Important: Place the unit on a flat surface. Rotating the adjustable feet cannot
compensate for extremely uneven surfaces.
3. When the EFX is level, tighten the lock nut.
4. When you are finished adjusting the EFX, place the unit on the floor and
recheck that it sits evenly on the floor.
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Precor EFX 225 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Precor EFX 225 in the language / languages: English as an attachment in your email.

The manual is 7,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info