334501
26
Zoom out
Zoom in
Previous page
1/30
Next page
26
IT GB FR
da soddisfare quanto
indicato sulla targa
matricola applicata sul
fondo del piano;
- che l’impianto sia
munito di un efficace
collegamento di terra
secondo le norme e le
disposizioni di legge in
vigore. La messa a
terra è obbligatoria a
termini di legge.
Nel caso che l’apparec-
chiatura non sia munita
di cavo e/o di relativa
spina utilizzare
materiale idoneo per
l’assorbimento indicato
in targa matricola e per
la temperatura di
lavoro. Il cavo in
nessun punto dovrà
raggiungere una
temperatura superiore
di 50
°
C a quella
ambiente.
Desiderando un
collegamento diretto
alla rete, è necessario
interporre un inter-
ruttore onnipolare con
apertura minima fra i
contatti di 3 mm
dimensionato per il
carico di targa e
rispondere alle norme
in vigore (il cavo di
terra giallo/verde non
deve essere interrotto
dall’interruttore). La
presa o l’interruttore
onnipolare devono
essere facilmente
raggiungibili con
l’apparecchiatura
installata.
N.B.: - Il costruttore declina
ogni responsabilità nel caso
che quanto sopra e le usuali
norme antiinfortunistiche
non vengano rispettate.
plate placed at the bottom
of the working area;
- that the plant is fitted
with an efficient earth
connection, following the
standards and law
provisions in force. The
earth connection is
compulsory in terms of
the law.
Should there be no cable
and/or plug on the
equipment, use suitable
absorption material for
the working temperature
as well, as indicated on
the matrix plate. Under no
circumstance must the
cable reach a temperature
above 50°C of the
ambient temperature.
Should a direct
connection to the network
be required, it will be
necessary to interpose an
omnipolar switch with
min. aperture between the
3 mm. contacts,
dimensioned to bear the
plate load and it must
follow the standards in
force (the yellow/green
earth cable must not be
interrupted by the
switch). The plug or
omnipolar switch must be
easily reached on the
installed equipment.
The manufacturers decline
any responsibility in the
event of non-compliance
with what is described
above and the accident
prevention norms not being
respected and followed.
toutes les indications
portées sur la plaque
signalétique située sous
l’appareil;
- que l’installation
dispose d’un
raccordement à la terre
secon les normes et les
dispositions en vigueur.
La mise à terre est
obligatoire aux termes
de la loi.
Si l’appareil n’a pas de
câble et /ou de prise
correspondante,
utiliser de la matière
apte à l’absorption
indiquée sur la plaque
signalétique et à la
température de travail.
Le câble ne devra
jamais atteindre une
température supérieure
de 50
°
C à celle
ambiante.
Si on désire une
connexion directe au
réseau, il faut prévoir
un dispositif de
coupure omnipolaire
avec une distance
d’ouverture entre les
contacts de 3 mm
dimensionné à la
puissance de plaque et
qui suit les normes en
vigueur (le fil de terre
de couleur jaune/vert
ne doit pas être coupé
par l’interrupteur). La
prise ou l’interrupteur
omnipolaire doivent
être facilement
accessibles après la
mise en place de
l’appareil.
Le Constructeur décline
toute responsabilité au cas
où ces normes et les autre
normes contre les accidents
ne seraient pas observées.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Praxis ik 601 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Praxis ik 601 in the language / languages: Dutch as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info