534698
43
Zoom out
Zoom in
Previous page
1/54
Next page
3. Operation
UP! 3D Printer User Manual 42
IMPORTANT NOTE: Before you enter any new calibration values, always click the
―Reset‖ button, otherwise the new values get added to the old ones. Before you enter any
new values, the bar at the very top of the screen should read: XY: 0.00 deg / XZ: 0.00 deg.
Next, take down the Front Centre ‗L shaped component, and measure its
deviation. Put the exact value into the Z box. If it deviates to the right side, the
value to be put into the Z box will be a positive value. If the deviates to the left,
the value to put into the Z box will be a negative value.
Finally, measure the height of Front Center component, which should be
40mm if it is not scaled. Enter the exact measured value into the ―H‖ box of the
―Calibrate dialogue box.
Click ―OK‖ to record all these values and exit the calibration window.
Cleaning the nozzle
After a lot of printing, the nozzle may be covered with a layer of oxidized ABS.
When the printer is printing, this oxidized ABS may melt on the nozzle, and may
create discolored spots the model. To avoid this you need to regularly clean the
nozzle.
Firstly, preheat the nozzle in order to melt the oxidized ABS. Use the ―Extrude‖
button on the ―Maintain‖ dialogue box, then lower the platform to the bottom.
Lastly, use some heat-resistant material, like 100 percent cotton cloth or soft
paper. A pair of tweezers will also be required. Then clip paper or some other
heat-resistant things with tweezers to clean up the nozzle.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PP3DP Up Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PP3DP Up Plus in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info