534698

PP3DP Up Plus Manual

36
Zoom out
Zoom in
Previous page
1/54
Next page
3. Operation
UP! 3D Printer User Manual 35
4. Printing
TIP: One of the keys to successful printing on the Up is platform preparation
and preheating. Particularly with large parts, there is a tendency for the
edges of the part to lift from the platform (which is a little colder than the
center) and cause the parts to warp. The best way to prevent this is to
ensure that a) the platform is perfectly level, b) that the nozzle height is
correctly set and that c) the platform is very well preheated. It also helps to
run the printer in a room that is not too cold (ie warmer than, say, 18C and
free of drafts.
Please ensure the following points are taken care of before printing:
Connect the 3D printer, initialize it, and set up the printing system. Load the
model and place it properly on the virtual platform of the software window.
Check if there is enough material for the model (the software will, generally,
tell you if there is not enough material when you begin the print). If not,
change the reel to a new one.
For large models (over 40mm2) results can be improved by preheating the
build platform. Click the ―Preheat‖ option on the ―3D Print‖ menu and the
printer begins to heat the platform. Let the platform get up to 100C before
beginning to print.
The little ―door‖ in the wind barrier of extrude head
is used to adjust the airflow to have good printing
quality for some certain models. Generally, it should
be closed (like the right picture), since warping or
or split issue would be caused if blow too much.
Only for the ball-shaped models and models with very small features or
sharp end (like tower), the ―door‖ should be opened. Because the heat from
the extrude head would be blown away soon with much blow, and models
can be solidified in a very short time so that the surface would be better.
Click menu ―3D Print->Print‖, and the print dialog box pops up. Choose
―Preferences‖ to set the printing parameters. Click ―OK‖ to begin to print.
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PP3DP Up Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PP3DP Up Plus in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info