534698
32
Zoom out
Zoom in
Previous page
1/54
Next page
3. Operation
UP! 3D Printer User Manual 31
The default value for this parameter is set to 2mm.
Nozzle: represents the distance between nozzle and the print platform when it
is at the bottom position. It is essential that this value be correctly set for good
printing. See section 3.3.2. for instructions on calibrating your printer.
Part Options
Surface: This parameter determines how many layers form the bottom face of
a part when it is not solid. For example, if you set it to 3, the machine will print 3
complete layers before going into non-solid mode. This does not, however,
affect the side wall thickness on non-solid parts, which are all the same
thickness (approximately 1.5mm) irrespective of the fill mode.
Angle: The part Angle determines at what point solid (dense) support material
gets used. If the angle is small than the printer will add solid fill layers under the
part surface. The thickness of this solid (dense) support is determined by the
―dense‖ parameter under the Support options as described below.
Fill Options
There are four ways to fill the interior of the parts, as described below.
The Part is made of nearly solid plastic, which gives you
the strongest part. This setting is recommended for
functional engineering parts. On previous software
version this was referred to as ―Solid‖
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PP3DP Up Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PP3DP Up Plus in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info