534698
27
Zoom out
Zoom in
Previous page
1/54
Next page
3. Operation
UP! 3D Printer User Manual 26
3.3.3 Leveling the print platform
After you have correctly calibrated your nozzle height, check that the nozzle is
at the same distance at all four corners of the print platform. If it is not, you may
need to adjust the platform until it is level with the nozzle at all 4 corners. There
are 3 screw and 3 spring washers under the platform heater.
Loosen a screw and the related corner of platform will rise. Tighten, or loosen,
the screws until you have the same gap between the nozzle and the platform
at all four corners of platform.
Modification: One of the Up forum users, Drew Petitclerc, reports an improved
level adjustment system, in which he has replaced the spring washers with a
small stack of rubber disks which allows much more freedom and precision in
leveling the platform. He removed the three shorter M3 screws and spring
washers and replaced them with a stack of high temp stiff rubber disks
centered between the three longer M3 screws. You adjust the level by
tightening the appropriate screws and compressing the disks. Always adjust by
tightening the screws, never by loosening them. The stack gives you a central,
compressible, pivot point and three screws are optimal for balance. Add or
remove disks to set overall Z spacing of plate to support arm.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PP3DP Up Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PP3DP Up Plus in the language / languages: English as an attachment in your email.

The manual is 4,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info