685364
21
Zoom out
Zoom in
Previous page
1/42
Next page
Once the engine has started, check the APU for coolant, fuel, oil and exhaust
leaks. Place the APU cover on the unit.
With a multi-meter, check the voltage at the AC power outlet box in the sleeper of
the truck. Voltage should read between 120 to 125 volts AC.
Allow APU to run for approximately 10 minutes and check again for coolant, oil,
fuel and exhaust leaks. After checking the APU over thoroughly, test the heating and air
conditioning unit for proper operation. Allow the APU to run for 30 minutes with the
heating and air conditioning unit in operation. This will put a load on the APU and allow
the unit to build up more heat. At the end of the 30-minute time period, turn the heating
and air conditioning unit off and push the driver control panel switch to the OFF Position.
Remove the front cover and check for coolant leaks. If no leaks are visible, replace front
cover.
Congratulations, The installation is complete.
18
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerTech PT-3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerTech PT-3000 in the language / languages: English as an attachment in your email.

The manual is 3,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info