685364
10
Zoom out
Zoom in
Previous page
1/42
Next page
INSTALLING THE PT-3000
PREPERATION OF PT-3000
Select the location for the PT-3000. Determine if you will need spacers to clear
any bolts or anything that may interfere with installing the unit to the frame rail. If
spacers are required, longer mounting bolts may be required for the install.
LOCATE THE PT-3000 ON THE FRAME RAIL
When choosing a location for the PT-3000, several things need to be considered.
Vehicles with a longer wheel base should have the PT-3000 mounted to avoid
obstructions in the road such as railroad tracks, speed bumps, curbs, etc. Each truck is
different and may require a different installation process. Before beginning the
installation, lay out the placement of all the components that will be installed.
The PT-3000 is designed to be mounted on the existing frame rails of the truck.
Mounting the unit on the frame rail with supplied frame angle brackets and hardware is
the only acceptable installation. Fabrication of another mounting rail may be unsafe with
the given weight and balance of the unit.
Standard PT-3000 Location: Vehicle passenger side.
This is the standard installation choice. Replaces steps into vehicle cab or further
back by the cat walk. Some trucks have steps to the catwalk on the drivers’ side frame
rail, however the passenger side will usually have fewer obstructions.
Alternate PT-3000 Location: Vehicle Driver Side.
This is a secondary installation location. It may be necessary to remove existing
steps to the catwalk.
Radiator must have free air flow with no obstructions
Radiator must be protected from grease sling
Cooling air for the PT-3000 engine and generator is drawn into the enclosure
through an air duct and discharges through the rear panel. These areas must remain free
of any obstructions that would restrict normal air flow.
ASSEMBLE THE MOUNTING BRACKETS
The PT-3000 comes with all the hardware required for the complete installation of
the unit. The loose parts contain all the necessary bolts, nuts and washers for assembling
the frame rail mounting angle brackets.
7
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for PowerTech PT-3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of PowerTech PT-3000 in the language / languages: English as an attachment in your email.

The manual is 3,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info