621129
12
Zoom out
Zoom in
Previous page
1/28
Next page
There may be significant risks as a result of any
unauthorised repairs.
The same regulations apply to accessory parts.
Güde GmbH & Co. KG will not be held liable for any
damage caused by the following:
Damage to the appliance as a result of mechanical
influences and overloading.
Change to the appliance
Use for purposes other than those specified in the
Operating Instructions.
All safety instructions need to be necessarily
followed to prevent any injuries and damage.
Important appliance-specific safety
instructions
A flat and non-slip place of work with sufficient free
movement must be provided before working with the pole
saw.
Switch the pole saw off and unplug it when leaving the
place of your work.
Remove any wooden waste and items no longer needed
from the place of your work.
Do not cut near flammable liquids or gases.
Defective chains must be immediately replaced.
Sawing branches out should be done on a sawhorse.
Watch out for falling branches. Check the tree to be saw
out. Make a room for falling branches.
Do not stand on a ladder or any other unstable equipment
when using the pole saw. Use both hands when working
with the saw. Apply firm, constant pressure on the chain
saw when cutting. Do not use the pole saw for sawing out
branches with a diameter exceeding the chain bar.
Keep other persons out of reach of the cutting end of the
pole saw – and in a safe distance from the place of your
work.
Do not stand directly under the branch to be cut off. Stand
always outside the falling branches.
Caution: The saw may only be used in a system with
safety switch against stray current (FI)!
Saw head angle adjustment
Caution! Adjustment to be performed with the
appliance being switched off only!
The saw head can be locked in 3 various cutting angles, which
enables individual working.
Press the locking screw (pic. 1/4) and put the saw head to the
required working position. Fixate the saw head in the required
position using the locking screw (pic. 1/4).
Safety instructions fort he operator
Do not use the appliance before reading carefully the
Operating Instructions.
Follow all safety instructions included in the Operating
Instructions.
Behave responsibly to other persons.
Walk, do not run when working.
Use the right working clothes at all times.
Operation
1. Connect the saw with the extension cable. Plug the
extension cable.
2. Use both hands to hold the saw. When operating
the chain saw (pic. 10), use only the specified points of
gripping. Hold the saw properly. Thumbs and fingers
must embrace the chain saw handle and pole.
3. Make sure your legs are positioned properly. Distribute
your weight evenly to both legs.
4. To start the appliance, press the stop first and then
On/Off. By this, the chain saw will be started. The chain
saw gets switched off by releasing On/Off. Make sure
the saw runs at full speed before performing first cut.
CAUTION: To support the saw, use the stop surface
on the cutting head at all times!
After starting the cut, guide the rotating chain to the wood.
Keep the chain saw firmly in hands to prevent any rejection or
slip (lateral movement) of the saw.
5. Guide the chain saw with slight pressure. Do not
overload the chain saw. Otherwise, the engine may get
overloaded and burn down. The saw works better and
safer at the specified speed.
6. Move away from the cut with the chain saw when still
running at full speed. Switch the chain saw off by
releasing the starter. The chain saw must be stopped to
the full extent before being put away.
CAUTION:
Prevent any backlash. A backlash may cause serious
injuries.
Do not use the chain saw when standing on a ladder or
any other unstable equipment and when in an unstable
position.
Contact a professional to help you if circumstances
require use of bigger appliances.
Marking
Product safety:
Product corresponds to
applicable EU standards
Tested by Intertek
Prohibitions:
General prohibition
(in connection with another
icon)
Do not use the appliance
when raining
No pulling / carrying by cable
Warning against dangerous
backlash!
Warning:
Warning/Caution
Warning against flying
items
Keep safe distance
Commands:
Read the Operating
Instructions!
Wear protective glasses
and ear protectors!
12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powertec Garden GAK 710 TELE 05167 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powertec Garden GAK 710 TELE 05167 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info