481030
17
Zoom out
Zoom in
Previous page
1/22
Next page
POWXQ5360 EN
Copyright © 2010 VARO P a g e | 17 www.varo.com
Fig 24
First unlock the sliding table by moving the transport lock and unscrewing the screw nut
below the table.
Remove the rip fence and place the miter gauge in the miter gauge groove on the table.
Raise the blade until it is approximately 1/8” (3.2 mm) above the top of the work piece.
Hold the work piece firmly against the miter gauge, with the path of the blade in line with
the desired cutting line. Move the work piece to within 1” (2.5 cm) of the blade.
Start the saw, and wait for the blade to reach full speed. Do not stand directly in line with
the saw blade’s path. Instead, stand on the side where the cut is being made.
Keep the work piece against the face of the miter gauge and flat against the table. Slowly
push the sliding table with the work piece through the blade.
Do not attempt to pull the work piece backward while the blade is turning. Turn the switch
OFF, and wait until the blade has come to a complete stop before carefully sliding the
work piece out.
In order to avoid instability, always place the larger surface of the
workpiece on the table when crosscutting and/or bevel crosscutting.
9.9 Bevel crosscutting 0° - 45° blade bevel & 90° miter angle (fig25)
This operation is the same as crosscutting, except that the blade is at a bevel angle other than
0°.
Fig 25
Adjust the blade to the desired
angle, and then tighten the blade
bevel locking knob.
Tighten the miter locking handle at
90°.
Hold the work piece firmly against
the face of the miter gauge
throughout the cutting operation.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POWXQ5360 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POWXQ5360 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POWXQ5360

Powerplus POWXQ5360 User Manual - German - 22 pages

Powerplus POWXQ5360 User Manual - Dutch - 23 pages

Powerplus POWXQ5360 User Manual - French - 21 pages

Powerplus POWXQ5360 Additional guide - All languages - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info