POWXG6281 EN
Copyright © 2020 VARO P a g e | 9 www.varo.com
8 OPERATION
Before connecting to the mains supply, always check the switch is in off
position!
8.1 Adjusting the cutting height (Fig. 3a & 3b)
Make sure your machine is switched off and the knife has come to a
complete standstill before adjusting the cutting height.
ATTENTION: The blades continue to rotate for a few seconds after the
machine is switched off, a rotating blade can cause injury.
For the first cut of the season .a high cutting adjustment should be selected.
The cutting height can be selected among 25 mm to 75 mm.
▪ To raise the blade height, grasp the height adjusting lever (17) and move it toward the
back of the mower. (Fig. 3a)
▪ To lower the blade height, grasp the height adjustment lever (17)and move it toward the
front of the mower. (Fig. 3b)
8.2 Power connection
The mains voltage (220-240 V) indicated on the rating plate must correspond with the mains
power supply. Mains connection fuse: min. 10A.
▪ Insert the plug of the mower into the socket of the extension cable.
▪ To prevent the extension cord from disconnecting during use, fit the extension cord
(socket end of cord) through the loop of the cable strain relief and secure over the hook
before connecting the plug.
8.3 Switching on and off (Fig. 4)
WARNING ！ Do not switch on the unit until it has been completely
assembled. Before switching on the unit, always check the connection cable
for signs of damage, only undamaged connection cable may be used.
Note: Damaged connection cables are highly dangerous!
If you try to start the lawn mower in long grass, the motor might overheat
and become damaged.
▪ Switch on: firstly press the safety button (5) on the combined switch and keep it down,
then pull the switch lever (6) and hold it pressed.
▪ Switch off: release the switch lever (6).
Note: While mowing, lay the connection cable safely on footpaths and on
areas which have already been mown.
WARNING！When the motor has been switched off, the cutter continues
running for several seconds therefore do not touch the underside of the
mower until the cutter has come to a standstill!
