POWXG6281 EN
Copyright © 2020 VARO P a g e | 8 www.varo.com
▪ Replace worn or damaged parts for safety.
▪ Not to connect a damaged cord to the supply or touch a damaged cord before it is
disconnected from the supply. A damaged cord can lead to contact with live parts.
▪ Not to touch the blade before the machine is disconnected form the supply and the blade
have come to a complete stop
▪ To keep extension cords away from the blade. The blade can cause damage to the cords
and lead to contact with live parts.
▪ Children should be supervised to ensure that they do not play with the appliance.
▪ This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
▪ If the external flexible cable or cord is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard
▪ Follow the instructions for safe use, including the recommendation that it must be supplied
with a Residual Current Device (RCD) with a tripping current of not more than 30 mA.
▪ Completely uncoil your extension cable before use to prevent overheating and loss of
mower efficiency. When tidying away the cable, wind it carefully to avoid kinking.
▪ Before use check the supply and extension cord for signs of damage or ageing. If the cord
becomes damaged during use, disconnect the cord from the supply immediately.
▪ Do not cross roads or gravel paths with the machine still running.
7 ASSEMBLY
See Fig.2 a-h
▪ Connect the right lower handle and the housing with supplied clamping screws.(Fig.2c) as
follows:
▪ insert the screw pin (B) into the fast lock button (C), then insert the screw (A) from right to
left through the insert screw pin.
▪ slide (from left to right) the right hand lower handle (D) over screw (A) , followed by ring
(E), than the lower rod fixed block (F) and at last spring (G)
▪ Repeat in the same order the left lower handle as described above and make sure that the
indicators on the left and right lower rod fixed block are at the same level (if not rotate the
lower rod fixed block halfway and make sure that both left and right lower handles are at
the same level).
▪ Put the cable strain relief (12) on the upper handle (at side of the switch).(Fig.2a)
▪ Connect upper and lower handle with supplied washer and clamping screws.(Fig.2b)
NOTE : Keep cable on the upper side of upper handle part. Connect the cable to the
handle tube using the 2 supplied cable clamps.
▪ Fit each wheel on the axle (respect large wheels on rear axle, small wheels on front axle),
put washer over axel, insert split pen in the hole of the axle and secure it (bend split pin
legs open), then press the wheel covers into place (Fig.2d &2h)
▪ Fix the cable holders.(Fig.2e)
▪ Grass collection box assembly.(Fig.2f): fix lower left and right part together, then fit the
top to this assembled unit.
▪ Lift the flap and place the grass box over the lugs.(Fig.2g)
