POWX410 EN
Copyright © 2018 VARO NV P a g e | 6 www.varo.com
▪ When the switch is put in the test position (= POWER switch ‘ON’), the indicators display
the condition of the batteries. The red lamp of the 12V DC input will then go off and the
battery will no longer be charged. (See battery condition indicators below.)
BATTERY CONDITION LIGHTS
Do not drive with power station while charging.
8 OPERATING INSTRUCTIONS
8.1 Jump start
Under no circumstances allow the red and black clamps to touch each
other or a common conductor.
▪ Switch off the engine of the vehicle or
boat.
▪ Connect the “+“(red) cable to the positive
terminal of your car battery. Then connect
the “-“（black）cable to the engine,
vehicle frame, or remote ground.
▪ Do not connect the negative clamp to the
negative battery terminal!
▪ Connecting to the negative battery terminal is an unsafe practice and increases the
possibility of sparking near the batteries explosive gases.
▪ Now you can start your engine. As soon as your car is started disconnect the cables from
your car in the reverse order.
▪ If your battery is so dead that your ignition light does not come on let the Power Station
stay connected to your battery for 10-20 minutes prior to attempting to start your car.
8.2 Compressor operation
DO NOT OVER INFLATE!
▪ This air compressor is designed for light duty.
▪ Please allow the air compressor to cool if operating for more than 10 continuous minutes.
▪ This air compressor and any other electrical device should be kept away from all children.
OPERATING INSTRUCTIONS
