POWX2040 EN
Copyright © 2022 VARO P a g e | 11 www.varo.com
10.2 Lubrication
▪ The machine requires no additional lubrication.
10.3 Regular checks (Fig. A)
After about 10 hrs. of use we recommend checking or maintaining the following points:
▪ First remove the gear cover (6) :
▪ Movement of the in feed and out feed rollers, cleaning if necessary.
▪ Movement of the pulley.
▪ Check the feed belts
▪ Check the tightness of the nuts, gears, chains, table adjustment of the planer.
▪ Check the carbon brushes
10.4 Replacing the belt :
▪ Remove the old belt and replace it with a new one, turning the belt gradually until it is
firmly in place on each of the 2 pulleys.
10.5 Replacing carbon brushes
▪ Remove and check the carbon brushes regularly. Replace them when they have become
shorter then 5mm. Keep the carbon brushes clean and free to slip in the holders. Both
carbon brushes must be replaced at the same time. Only use original carbon brushes.
To replace :
Turn the appliance upside down and unscrew and remove the base. Remove the cover of the
carbon port and replace the carbons. Then close the cover again and screw the base back on.
It is recommended to have parts replaced by a trained technician.
11 TECHNICAL DATA