POWX2040 EN
Copyright © 2022 VARO P a g e | 8 www.varo.com
▪ Align laterally so that no element protrudes to the right or left.
▪ Make sure the 2 slots (e) in the cutter (a) sit onto the 2 cutter height setting screws (d).
▪ Refit the spacer block (b) with the 4 bolts (c) screwed in but not tightened, the bolts (c)
need to be slightly loose to make adjustment of the cutter (a) possible.
▪ Once installed you should make sure that the cutters are sitting properly in their sites. To
do so, use the cutter setting jig (f) provided with the appliance.
▪ The cutter setting jig (f) should be placed on the outfeed table (2) with the lower edges (g)
against the edge of the outfeed table.
▪ Adjust the position of the cutter (a) by turning the cutter shaft until the cutter (a) is centered
between the in- and outfeed table (1) & (2).
▪ The cutter (a) must touch both bar curves (h) of the setting jig equally.
▪ Adjust the cutter position bolts (i) until the cutter sits correctly as described above.
▪ Re-tighten the 4 bolts (c) of the spacer block, and repeat above process for the second
cutter.
▪ To install new cutters: proceed as above but use new cutters.
NOTE : Adjusting or replacing the cutters is a precise job ! The cutters must
be set correctly and perfectly level and centered. Badly adjusted or
replaced cutters will result in poorly finished surfaces and unstable
performance which may result in personal injury ! We recommend having
this job done by a qualified technician.
!! Handle the blades carefully to avoid risk of accidents. Do not touch the
blades with your fingers.
7.7 Mounting the extraction hood (Fig. F)
For a better dust extraction of the working surface, your machine can be
connected to a vacuum cleaner. Attention: Dust particles can cause
respiratory problems. For your protection, it is recommended that a
standard anti-dust mask be used.
The machine is fitted with an interlocking safety switch and will not run
without the dust extraction hood correctly fitted
The hood can be fitted in two different ways, depending on what type of operation is being
carried out: Planing or Thicknessing
The hood is locked in place using two locking latches which push into a receiver. One located
on each side of the table.
Planing Operations
The dust extraction hood must be fitted underneath the outfeed table and locked in place using
the two locking latches.
Thicknessing Operations
Remove the fence The extraction hood is then fixed on top of the outfeed table and locked in
place using the two locking latches.
