POWX00450 EN
Copyright © 2020 VARO P a g e | 6 www.varo.com
and an intense current will flow causing heat generation which may lead to casing rupture
or fire.
▪ Do not heat. If batteries are heated to above 100 °C, sealing and insulating separators
and other polymer components may be damaged resulting in electrolyte leakage and/or
internal short circuiting leading to heat generation causing rupture or file. Moreover do not
dispose of the batteries in fire, explosion and/or intense burning may result.
▪ Under extreme conditions, battery leakage may occur. When you notice liquid on the
battery, proceed as follows:
• Carefully wipe the liquid off using a cloth. Avoid skin contact.
• In case of skin or eye contact, follow the instructions below:
o Immediately rinse with water. Neutralize with a mild acid such
as lemon juice or vinegar.
o In case of eye contact, rinse abundantly with clean water for at
least 10 minutes. Consult a physician.
Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do
not incinerate the battery.
7.2 Chargers (8)
▪ Use the charger provided with the tool only to charge the battery
▪ Never attempt to charge non-rechargeable batteries.
▪ Have defective cords replaced immediately.
▪ Do not expose to water.
▪ Do not open the charger.
▪ Do not probe the charger.
▪ The charger is intended for indoor use only.
8 FEATURES
8.1 Li-ion battery (9)
Advantages of Li-ion batteries :
▪ Li-ion batteries have a higher capacity/weight ratio (more power for less heavy, more
compact, battery)
▪ No memory effect (capacity loss after several charge/discharge cycles) like other type
batteries. (Ni-Cd, Ni-MeH ..).
▪ Limited self discharge. (also see chapter : Storage)
8.2 Keyless chuck (1)
A keyless chuck is included on your drill to allow for easy installation and removal of
bits/accessories. The chuck is divided into two parts. The rear is called the collar and the front
is called the body.
To open and close the keyless chuck, grasp and hold the collar of the chuck with one hand
and rotate the chuck body with your other hand. The arrows on the chuck indicate in which
direction to rotate the chuck body in order to GRIP (tighten) or release (unlock) the drill bit.
WARNING: Do not hold the chuck body with one hand and use power of the
drill to tighten or loosen the juck jaws. The chuck body could slip and your
hand could come in contact with a rotating accessory. This could cause an
accident resulting in personal injury.
