POWEG9020 EN
Copyright © 2021 VARO P a g e | 10 www.varo.com
▪ Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen
surfaces when water is available.
▪ Conserve water by using power blowers instead of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills, porches and gardens.
▪ Use intermediate tube plus nozzle of your choice so the air stream can work close to the ground.
▪ After using blowers and other equipment, CLEAN UP! Dispose of debris in trash receptacles.
10.5 Operation instructions
▪ Follow the instructions “STARTING A COLD ENGINE”.
▪ once unit is running, place unit on your back by slipping arms through the shoulder straps as if you
were putting on a jacket
▪ When preparing to clear an area of debris, always position yourself so that you can control the
direction debris will be blown.
▪ The control handle and the flexibility of the blower tube assembly will allow you to clear the most
hard–to-reach areas.
▪ The hand grip ,throttle trigger, throttle lock and ignition on/off switch(B)are all mounted on a swivel
handle that offers a wide range of operating positions and comfort
11 MAINTENANCE
11.1 Air filter (Fig.12 & 13)
CAUTION: NEVER operate blower without the air filter or dust and dirt will be sucked
into the engine and damage it. The air filter must be kept clean. If it becomes damaged,
install a new filter.
TO Clean Air Filter:
▪ Turn the knob holding the air filter cover (7) in place counter clockwise, remove, cover (7) and lift
filter (C) from air box .
▪ Wash filter in soap and water. DO NOT USE GASOLINE!
▪ Air dry filter.
▪ Reinstall air filter and air filter cover.
NOTE: Replace filter if frayed, torn, damaged or unable to be cleaned.
11.2 Fuel cap / fuel filter (Fig.14, 15 & 16)
CAUTION: Remove fuel from unit and store in approved container before starting this
procedure. Open fuel cap slowly to release any pressure which may have formed in
fuel tank
NOTE: Keep vent (A) on fuel cap (10) clean of debris(Fig. 14).
Fuel filter.
▪ Completely remove fuel cap (10) from fuel tank (9) to be able to remove fuel filter (C) from tank.
Use a piece of wire with a hook formed at the end to pull filter out of tank.
▪ Pull off fuel filter (C) with a twisting motion.
▪ Replace fuel filter.
NOTE: Never operate the blower without the fuel filter. Internal engine damage could
result!
