POWEG9020 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
9.2 Mixing fuel
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to mix with
oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must be mixed
at 30:1.
9.2.1 Fuel and lubrication symbols
9.2.2 Fuel and lubrication symbols
9.2.3 Recommended fuels
Some conventional gasolines are being blended with oxygenates such as alcohol or an ether
compound to meet clean air standards. The engine is designed to operate satisfactorily on any
gasoline for automotive use including oxygenated gasolines.
10 OPERATING INSTRUCTIONS
10.1 Starting a cold engine (Fig.8,9 & 10)
▪ Make sure ignition switch (3) is in the ON (I) position.
▪ Pump primer bulb (12) 6 times by pressing up on the bulb (12).
▪ Your unit is designed with a 2 position choke (8) : FULL CHOKE ,and RUN .
▪ With the unit on the ground, hold the top assist handle (4) and step on the top of the frame with
your foot.
▪ Position the choke lever (8) to full choke and pull starter handle (5) 2-3 times until you hear
the engine turn over to begin to start, than position choke to Run and pull 3-4 more times
until the unit starts.
