POWEB4010 EN
Copyright © 2017 VARO P a g e | 9 www.varo.com
WARNING: Never use the machine for sanding magnesium work piece.
10 GENERAL OPERATING INSTRUCTIONS
▪ Turn on the sander using the ON/OFF switch trigger (2).
▪ Run the sander for a few seconds before contacting the workpiece.
▪ Contact the workpiece with minimal pressure. If the sander is not removing enough
material, try a grittier piece of sandpaper. If you want to remove a lot of material fast, use a
belt sander.
Note: All orbital sanders leave sanding marks on the workpiece. To
minimize sanding marks, always try to sand with the grain of the wood.
▪ Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.
▪ When you are finished, turn off the switch.
▪ Allow the tool to come to a complete stop before setting it down.
▪ To prevent accidents, turn off the tool and disconnect its power supply after use. Clean
and then store the tool indoors out of children’s reach.
11 TECHNICAL DATA
13 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
13.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.