POWEB3510 EN
Copyright © 2018 VARO P a g e | 9 www.varo.com
10 OPERATION
10.1 Switch on/off (Fig. 6)
Before engage the ON/OFF switch button, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
▪ Connect the battery pack onto the angle grinder body.
▪ Your switch is locked off to prevent accidental starting.
▪ To switch on your tool, push the safety switch lever (11) forward and depress ON/OFF
switch trigger (3) fully. Now your tool is switch on. To switch off your tool, just release the
ON/OFF switch trigger.
WARNING: The wheel continues to rotate after the tool is switched off.
11 USE
11.1 Grinding
Hold the handle (2) and auxiliary handle (5) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at
an angle of 15-30° in relation to the item. Move the
grinder gently along the item. Give the grinder time to
work. It is rarely necessary to press the disc hard against
the surface to be worked. Sparks can occur in the motor compartment during use. This is
normal and does not mean the grinder is defective. Switch off the grinder after use.
12 CLEANING AND MAINTENANCE
12.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
