POWEB3510 EN
Copyright © 2018 VARO P a g e | 8 www.varo.com
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9 ASSEMBLY
9.1 Fitting the auxiliary handle (Fig. 3)
Warning: Prior to assembly and adjustment always switch off the grinder
and pull out the battery pack from the angle grinder body.
The auxiliary handle (5) can be attached to the angle grinder in 2 different positions: left and
right.
9.2 Assembly the protective guard (Fig. 4)
Warning: Prior to assembly and adjustment always switch off the grinder
and pull out the battery pack from the angle grinder body.
Use a screwdriver to loosen the screw and move the protective guard (6) to the desired
position and secure it firmly.
The protective guard must be positioned to protect the user if the disc shatters during use.
9.3 Replacing the grinding disc (Fig. 5)
Beware – a disc which has been used may be very hot!
Warning: prior to assembly and adjustment always pull out the battery pack
from the grinder body.
▪ Depress and hold down the spindle lock button (1) to secure the spindle.
▪ Turn the output spindle until it locks.
▪ Remove the outer flange and backing flange by using the two-hole spanner provided.
▪ Fit the desired disc (7) on the spindle and replace the outer flange and backing flange.
Release the spindle lock.
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel!
Switch the grinder on using the ON/OFF switch (3), and let it run for 30 seconds to check that
it is working correctly and that there are no abnormal vibrations. Stop the grinder immediately
if heavy vibration occurs, and investigate the cause.
For grinding disc and cutting wheel with a thickness up to approx. 3 mm, screw on the outer
flange with the flat side facing the grinding disc or cutting wheel.
