POWDPG7553 EN
Copyright © 2021 VARO P a g e | 17 www.varo.com
Always wear the harness and suitable protection clothing when working
with the device. Wear eye, hearing and head protection. Ensure that the
blade is installed correctly. Replace damaged or blunt tool parts. There is a
risk of injury.
▪ Only use the blade to work on open, even areas. Carefully inspect the area to be cut and
remove all foreign bodies. Avoid hitting stones, metal or other obstacles. The blade can be
damaged and there is a risk of kickback by the machine.
▪ When working, hold the cutter above the ground and slowly swivel the device back and
forth like a scythe in an equal arch.
▪ Do not hold the cutting head at an angle.
▪ Do not use the device to cut wild growth or brushwood.
▪ Regularly check the blades for damage and replace as needed.
10.10 Trimming procedures
When properly equipped with a debris shield and stringhead, your unit will trim unsightly
weeds and tall grass in those hard-to-reach areas - along fences, walls, foundations and
around trees. It can also be used for scalping to remove vegetation down to the ground for
easier preparation of a garden or to clean out a particular area.
NOTE: Even if you are careful, trimming around foundations, brick or stone
walls, curves, etc., will result in above-normal string wear. To renew the
wire, press the lower spool knob against the ground with rotating trimmer.
10.10.1 Trimming / mowing
Swing trimmer with a sickle-like motion from side to side. Do not tilt the stringhead during the
procedure. Test area to be trimmed for proper cutting height. Keep stringhead at same level
for even depth of cut.
10.10.2 Closer trimming
Position trimmer straight ahead with a slight tilt so bottom of stringhead is above ground level
and string contact occurs at proper cutting point. Always cut away from operator. Do not pull
trimmer in towards operator.
10.10.3 Fence / foundation trimming
Approach trimming around chain link fences, picket fences, rock walls and foundations slowly
to cut close without whipping string against the barrier. If the string comes in contact with rock,
brick walls, or foundations, it will break or fray. If string hits fencing, it will snap off.
10.10.4 Trimming around trees
Trim around tree trunks slowly so string does not contact bark. Walk around the tree trimming
from left to right. Approach grass or weeds with the tip of the string and tilt stringhead slightly
forward
10.10.5 Scalping
WARNING: Use extreme caution when SCALPING. Keep a distance of 30
meters (100 feet) between operator, other people and animals during these
operations.
Scalping refers to removal of all vegetation down to the ground. To do this, tilt the stringhead
to about a 30 degree angle to the right. By adjusting the handle you will have better control
