POWDP2580 EN
Copyright © 2022 VARO P a g e | 13 www.varo.com
10.1.1 Charging indication (Fig. 20b)
Connect the charger to the power outlet socket:
▪ Solid green: ready to charge.
▪ Flickering red: charging.
▪ Solid green: charged.
▪ Solid green and red: battery or charger damaged.
Note: If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the
specification chart. Do not charge any other battery pack or any battery
pack that does not securely fit the charger.
1. Frequently monitor the charger and battery pack while connected.
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
NOTE: Remove battery pack from charger stand which use your thumb or
fingers, press the battery’s release button in and pull the battery pack off at
the same time.
10.2 Battery capacity indicator (Fig. 20a)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button. Before using the machine, please press switch trigger to
check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are litt: Battery fully charged.
2 LED’s are litt: Battery 60% charged.
1 LED is litt: Battery almost discharged.
10.3 Inserting and removing the battery (Fig. 21a – 21b)
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
Risk of injury! In the event of a functional fault, immediately press the
On/Off switch and remove the battery pack.
10.4 Check before starting the device!
Risk of injury! The device may only be put into operation if there are no
defects. If a part is defective danger it must be replaced before the device is
used again.
Check to make sure the device is in safe operating condition:
▪ Check to make sure there are no visible defects.
