Manual Powerplus POW6128 (page 8 of 15) (English)

582041

Zoom out

Zoom in

1/15

POW6128 EN

7 ASSEMBLY

7.1 Fuel

This product is equipped with a 2-stroke engine and must be run with a petrol-oil mixture

(see technical data).

WARNING! This product is not supplied with fuel in the engine! Before

operating this product it is essential to fill it with fuel!

WARNING! Ensure that there are no naked flames around the product! Do

not smoke while filling fuel and oil!

 Place the product on a stable, level surface. We recommend laying a non-flammable

sheet under the product. Mix petrol and oil in the fuel mixing bottle (26).

NOTE: Never mix fuel and oil directly in the tank of the product.

 Unscrew and remove the fuel tank cap (10), then add the fuel mixture into the tank (9).

Use a fuel funnel fitted with a filter to avoid debris entering the tank and to avoid spilling.

Do not overfill. Leave a minimum 5 mm of space between the top of the fuel and the inside

edge of the tank to allow for expansion (Fig. 1).

 Wipe up spilled fuel with a soft cloth and refit the fuel tank cap (10).

7.2 Handle adjustment

The handle can be adjusted ± 90° to left and right side according to the required cut.

 Press the unlock button (14) down and hold it in its lower position (Fig. 2).

 Turn the handle (13) in desired direction to the end. Make sure the handle engages in

position (Fig. 3).

WARNING! Only adjust the handle position when the engine is switched off!

Always ensure that the handle locks in one of the end positions, never use it

in any other intermediate position.

8 OPERATION

8.1 Starting / Stopping

This product is controlled with the control handle. For operation three steps are necessary:

 First the ignition switch (11) must be put into its on position “I” (Fig. 4, a).

 Then the throttle interlock (12) must be pressed (Fig. 4, b) to disengage the throttle trigger.

 Finally press the throttle trigger (15) (Fig. 4, c).

8.1.1 Starting

 Place the product on a flat, stable surface. Ensure that the cutting blade in use does not

touch the ground or any objects.

 Set the ignition switch (11) to its on position “I” (Fig. 5).

 If the engine is cold, move the choke lever (19) to the “CLOSE” position and depress

the primer (23) seven times (Fig. 6a).

 If the engine is warm, move the choke lever (19) to the “OPEN” position , do not press

the primer (Fig. 6b).

 Hold the product stable and pull the recoil starter handle (7) firmly; repeat until the engine

starts (Fig. 7).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POW6128 in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POW6128

Powerplus POW6128 User Manual - German - 16 pages

Powerplus POW6128 User Manual - Dutch - 16 pages

Powerplus POW6128 User Manual - French - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Powerplus POW6128 Manual

Product: