480881
8
Zoom out
Zoom in
Previous page
1/14
Next page
POW60476 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
Important: Before starting the unit cut the cutting string to 13 cm in order to
avoid an engine overload during starting.
Place the unit on a firm and flat surface. Make sure the cutting components do not touch
any items or the floor.
Set the on/off stop control (7) to its "ON" position.
Press primer bulb 3 to 5 times, until the air bubbles out are
Shift the choke lever (13) to its position marked “CLOSE”.
Pull the starter rope grip a few times in order to provide the engine with enough fuel/air
mixture. Pull until the engine starts
Keep running until the motor is warm enough.
Move the choke lever around half open position.
Apply full gas and. •Let the engine run for 10 seconds in order to heat up. Push briefly the
gas lever (9), the engine will idle.
Move the choke lever (13) to its position marked “ON”.
If the engine does not start, repeat steps 2-10.
Attention! If the engine does not start after two attempts, try to start it
without choke. If even that does not work, then the engine is "flooded".
Follow the instructions specified in the chapter - "Engine does not start".
9.4 Engine starting (hot engine)
A hot engine is to be started without choke. Start it in the same way as a cold engine but make
the starting position around half way open.
9.5 Engine shutdown
Release the gas lever (9).
Turn off ignition by pressing on the on/off stop control (7).
9.6 Engine idle check
If the gas level is not pressed, the cutting components must not move during idle engine.
Attention! After the unit's shutdown the cutting attachment will keep spinning
for a few seconds.
9.7 General operating instructions
During engine starting and its operation keep the cutting components away from all body
parts, especially from hands and legs.
Regularly remove any dirt from the protective cover, the cutting attachment, and the
cutting device. The engine must be off during that activity.
9.8 Work with the spring spindle
Attention! Use only original cutting components. Use of metal wire instead
of plastic string is forbidden.
Always hold the cutting attachment close to the ground and slowly swing the unit. Do not hold
the cutting attachment under any angle and do not lift it above the ground.
Cut long grass through layers from its top downwards.
During cutting around trees, fence posts or other obstacles slowly proceed with the unit
around objects and cut grass with the string tips.
Avoid contact with solid items (stones, walls, wooden fencing etc.). The string may wear
out very rapidly.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Powerplus POW60476 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Powerplus POW60476 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Powerplus POW60476

Powerplus POW60476 User Manual - German - 15 pages

Powerplus POW60476 User Manual - Dutch - 15 pages

Powerplus POW60476 User Manual - French - 15 pages

Powerplus POW60476 Additional guide - All languages - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info