680967
19
Zoom out
Zoom in
Previous page
1/28
Next page
Adam | 19
EN
Installation with Opentherm thermostat
20,5°
20,5°
20,5°
Installation with zone thermostat Lisa
20,5°
20,5°
20,5°
Installation with thermostat Anna
(OpenTherm)
20,5°
20,5°
20,5°
Consult the manual of the boiler for
more information about the
connector of the boiler.
Unplug the boiler and Adam from the
electrical power.
Disconnect the thermostat wire
between the boiler and the
thermostat at the boiler boiler end of
the wire and connect the installation
cable with Adam at the boiler icon
.
Connect the wire running to the
thermostat with the installation cable
at Adam with the thermostat icon
.
This is not necessary if you install Adam
without an OpenTherm thermostat but with
zone thermostat Lisa.
Determine the position of Adam near
the boiler and mount the wall plate of
Adam to the wall.
Click Adam onto the wall plate.
Connect both the boiler and Adam to
the power outlet and wait until Adam
has started up: the upper
light and
light in the middle are blinking
slowly (Adam is in acces point mode).
Open the local web interface of Adam
in the web browser of your device
(setup.now or 192.168.40.40). Make
sure you are still connected to the
2. Connect to the boiler
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Plugwise Adam at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Plugwise Adam in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info