470699
56
Zoom out
Zoom in
Previous page
1/120
Next page
56
En
Additional Information
Symptom
The sound distorts.
You can only hear treble
from speakers.
No image is output when
an input is selected.
The settings have all been
cleared.
OVERLOAD blinks in the
display and the power
turns off automatically.
You can't set the subwoofer
frequency route.
The display is dark or off.
After making an adjust-
ment the display goes off.
The receiver cannot be re-
mote controlled.
Other components cannot
be remote controlled.
The shutter of the optical
terminal doesn’t close af-
ter removing plug.
Cause
The analog signal is too strong.
Master volume is too loud.
The front speakers are set to small.
The video connections are incorrect.
The input source is not properly selected.
The DVD/video player settings are incor-
rect.
The receiver has been unplugged or the
main power turned off for more than a
month.
There is a short in your speaker cable.
The output is too high.
All the speakers are set to either large or
NO (i.e. no speakers are set to small).
The DIMMER feature is set to dark or off.
The DIMMER feature is set to off.
The remote control batteries have worn
out.
You are too far away or at a bad angle for
operation.
There is an obstacle between the receiver
and the remote control.
Strong light such as fluorescent light.
The CONTROL terminal has been
hooked up.
The proper code hasn't been input into
the remote control to control that com-
ponent.
The remote control is in a mode to make some
setting or control something on the receiver.
Something is plugged into the "CON-
TROL IN Terminal " (see page 19).
The plug was inserted improperly.
Remedy
Turn on input attenuator (see page 30).
Turn the volume down.
Set the front speakers to large (refer to
page 28).
Make sure the video component is con-
nected correctly (refer to pages 11 to 14).
Make sure the proper component is se-
lected by pressing the correct function
button (see page 20).
Set correctly. Refer to the instruction
manual supplied with the DVD/video
player.
Set the receiver again (refer to page 26-
30).
Fix the short or get new speaker cable.
Turn the volume down.
Change the speaker settings (refer to page
27–29).
Press DIMMER on the remote control re-
peatedly to select a different brightness.
Press DIMMER on the remote control re-
peatedly to select a different brightness.
Replace the batteries (refer to page 10).
Operate within 7 m, 30° of the remote
sensor on the front panel (refer to page
10).
Remove the obstacle or operate from an-
other angle of position.
Avoid exposing the remote sensor on the
front panel to direct light.
Disconnect the CONTROL terminal.
Input the proper code into the remote
control (see page 47).
Press the button of the component you
want to control.
Either point remote at the remote
sensor of the unit that is plugged into
the "Control Terminal in" or unplug the
cable from the "CONTROL IN
Terminal" and use remote normally.
The terminal is fine but the shutter won’t
close.
If the unit does not operate normally due to external effects such as static electricity.
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-C550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-C550 in the language / languages: English, German as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info