470699
54
Zoom out
Zoom in
Previous page
1/120
Next page
54
En
10
Additional Information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
Cause
The power plug is disconnected.
The protection circuit may have been
activated.
Speaker wire may be touching the rear
panel.
Static electricity caused by dry air.
The receiver has a serious problem.
The receiver has gotten too hot.
The receiver has gotten too hot.
The thermistor (temperature sensor) is
out of order.
Improper connections.
Sound is muted.
The volume is turned down.
Incorrect frequency.
The antenna is not connected.
FM broadcasts
The FM antenna is not fully extended
or is poorly positioned.
Weak radio signals.
AM broadcasts
The AM antenna is poorly positioned.
Weak radio signals.
Interference caused by other equipment
(fluorescent lamp, motor, etc.).
The radio signal is too weak .
Symptom
The power does not
turn on.
AMP ERR blinks in
the display and the
unit turns off.
HEAT UP blinks in the
display.
OVERHEAT blinks in
the display and no
sound is output.
THDCT NG blinks in
the display and no
sound is output.
The unit does not
respond when the
buttons are pressed.
No sound is output
when the AM/FM is
selected.
Considerable noise in
radio broadcasts.
Broadcast stations
cannot be selected
automatically.
Remedy
Connect the power plug to the wall outlet.
Disconnect the power plug from the outlet,
and insert again.
Make sure there are no loose strands of
speaker wire touching the rear panel. This
could cause the receiver to shut off auto-
matically.
Disconnect the power plug from the outlet,
and insert again.
Unplug the receiver from the wall and call a
Pioneer-accredited repair center.
Allow the receiver to cool down with good
ventilation. If problem persists turn off re-
ceiver, unplug from wall and allow it to cool
down.
Turn the receiver off and allow it to cool
down with good ventilation. If problem
persists turn the volume down.
Turn the receiver off, unplug from wall and
call a Pioneer-accredited repair center.
Make sure the component is connected cor-
rectly (refer to pages 12–15).
Press MUTE on the remote control.
Adjust the MASTER VOLUME.
Tune in the correct frequency.
Connect the antenna (refer to page 18).
Fully extend the FM wire antenna, position
for best reception, and secure to a wall.
Connect an outdoor FM antenna (refer to
page 18).
Adjust the direction and position for best
reception.
Connect an additional internal or external
AM antenna (refer to page 18).
Turn off the equipment causing the noise or
move it away from the receiver.
Place the antenna farther away from the
equipment causing the noise.
Connect an outdoor antenna (refer to page
18).
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer VSX-C550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-C550 in the language / languages: English, German as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info