Manual Pioneer VSX-531D (page 9 of 41) (Finnish)

699667

Zoom out

Zoom in

1/41

Connecting your equipment

Placing the speakers

By connecting the left and right front speakers (L/R), the center speaker (C), the left and right

surround speakers (SL/SR), and the subwoofer (SW), a 5.1 ch surround system can be

enjoyed.

To achieve the best possible surround sound, install your speakers as shown below.

Hints on the speaker placement

Where you put your speakers in the room has a big effect on the quality of the sound. The

following guidelines should help you to get the best sound from your system.

•

The subwoofer can be placed on the floor. Ideally, the other speakers should be at about

ear-level when you’re listening to them. Putting the speakers on the floor (except the

subwoofer), or mounting them very high on a wall is not recommended.

•

For the best stereo effect, place the front speakers 2 m to 3 m apart, at equal distance from

the TV.

•

If you’re going to place speakers around your CRT TV, use shielded speakers or place the

speakers at a sufficient distance from your CRT TV.

•

If you’re using a center speaker, place the front speakers at a wider angle. If not, place

them at a narrower angle.

•

Place the center speaker above or below the TV so that the sound of the center channel is

localized at the TV screen. Also, make sure the center speaker does not cross the line

formed by the leading edge of the front left and right speakers.

•

It is best to angle the speakers towards the listening position. The angle depends on the

size of the room. Use less of an angle for bigger rooms.

•

The optimal positioning for surround speakers is just above ear height. Make sure the

speakers don’t face each other. For DVD-Audio, the speakers should be more directly

behind the listener than for home theater playback.

•

Try not to place the surround speakers farther away from the listening position than the

front and center speakers. Doing so can weaken the surround sound effect.

CAUTION

•

Make sure that all speakers are securely installed. This not only improves sound quality,

but also reduces the risk of damage or injury resulting from speakers being knocked over

or falling in the event of external shocks such as earthquakes.

120

5.1 channel surround system:

Connecting your equipment

Placing the speakers

By connecting the left and right front speakers (L/R), the center speaker (C), the left and right

surround speakers (SL/SR), and the subwoofer (SW), a 5.1 ch surround system can be

enjoyed.

To achieve the best possible surround sound, install your speakers as shown below.

Hints on the speaker placement

Where you put your speakers in the room has a big effect on the quality of the sound. The

following guidelines should help you to get the best sound from your system.

•

The subwoofer can be placed on the floor. Ideally, the other speakers should be at about

ear-level when you’re listening to them. Putting the speakers on the floor (except the

subwoofer), or mounting them very high on a wall is not recommended.

•

For the best stereo effect, place the front speakers 2 m to 3 m apart, at equal distance from

the TV.

•

If you’re going to place speakers around your CRT TV, use shielded speakers or place the

speakers at a sufficient distance from your CRT TV.

•

If you’re using a center speaker, place the front speakers at a wider angle. If not, place

them at a narrower angle.

•

Place the center speaker above or below the TV so that the sound of the center channel is

localized at the TV screen. Also, make sure the center speaker does not cross the line

formed by the leading edge of the front left and right speakers.

•

It is best to angle the speakers towards the listening position. The angle depends on the

size of the room. Use less of an angle for bigger rooms.

•

The optimal positioning for surround speakers is just above ear height. Make sure the

speakers don’t face each other. For DVD-Audio, the speakers should be more directly

behind the listener than for home theater playback.

•

Try not to place the surround speakers farther away from the listening position than the

front and center speakers. Doing so can weaken the surround sound effect.

CAUTION

•

Make sure that all speakers are securely installed. This not only improves sound quality,

but also reduces the risk of damage or injury resulting from speakers being knocked over

or falling in the event of external shocks such as earthquakes.

120

5.1 channel surround system:

Connecting your equipment

Placing the speakers

By connecting the left and right front speakers (L/R), the center speaker (C), the left and right

surround speakers (SL/SR), and the subwoofer (SW), a 5.1 ch surround system can be

enjoyed.

To achieve the best possible surround sound, install your speakers as shown below.

Hints on the speaker placement

Where you put your speakers in the room has a big effect on the quality of the sound. The

following guidelines should help you to get the best sound from your system.

•

The subwoofer can be placed on the floor. Ideally, the other speakers should be at about

ear-level when you’re listening to them. Putting the speakers on the floor (except the

subwoofer), or mounting them very high on a wall is not recommended.

•

For the best stereo effect, place the front speakers 2 m to 3 m apart, at equal distance from

the TV.

•

If you’re going to place speakers around your CRT TV, use shielded speakers or place the

speakers at a sufficient distance from your CRT TV.

•

If you’re using a center speaker, place the front speakers at a wider angle. If not, place

them at a narrower angle.

•

Place the center speaker above or below the TV so that the sound of the center channel is

localized at the TV screen. Also, make sure the center speaker does not cross the line

formed by the leading edge of the front left and right speakers.

•

It is best to angle the speakers towards the listening position. The angle depends on the

size of the room. Use less of an angle for bigger rooms.

•

The optimal positioning for surround speakers is just above ear height. Make sure the

speakers don’t face each other. For DVD-Audio, the speakers should be more directly

behind the listener than for home theater playback.

•

Try not to place the surround speakers farther away from the listening position than the

front and center speakers. Doing so can weaken the surround sound effect.

CAUTION

•

Make sure that all speakers are securely installed. This not only improves sound quality,

but also reduces the risk of damage or injury resulting from speakers being knocked over

or falling in the event of external shocks such as earthquakes.

120

5.1 channel surround system:

Laitteiden kytkeminen

Connecting your equipment

Connecting the speakers

The receiver will work with just two stereo speakers (the front speakers in the diagram) but

using at least three speakers is recommended, and a complete setup is best for surround

sound.

Make sure you connect the speaker on the right to the right (R) terminal and the speaker on

the left to the left (L) terminal. Also make sure the positive and negative (+/–) terminals on the

receiver match those on the speakers.

You can use speakers with a nominal impedance between 6 Ω and 16 Ω.

Be sure to complete all connections before connecting this unit to the AC power source.

Bare wire connections

CAUTION

•

These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric

shock when connecting or disconnecting the speaker cables, disconnect the power cord

before touching any uninsulated parts.

•

Make sure that all the bare speaker wire is twisted together and inserted fully into the

speaker terminal. If any of the bare speaker wire touches the back panel it may cause the

power to cut off as a safety measure.

Front speaker terminals:

Twist exposed wire strands together.

Loosen terminal and insert exposed wire.

Tighten terminal.

Center and surround speaker terminals:

Twist exposed wire strands together.

Push open the tabs and insert exposed wire.

Release the tabs.

12 3

12 mm

12 3

12 mm

LINE LEVEL

INPUT

Center

Surround right

Front right

Front leftSubwoofer

Surround left

Connecting your equipment

Connecting the speakers

The receiver will work with just two stereo speakers (the front speakers in the diagram) but

using at least three speakers is recommended, and a complete setup is best for surround

sound.

Make sure you connect the speaker on the right to the right (R) terminal and the speaker on

the left to the left (L) terminal. Also make sure the positive and negative (+/–) terminals on the

receiver match those on the speakers.

You can use speakers with a nominal impedance between 6 Ω and 16 Ω.

Be sure to complete all connections before connecting this unit to the AC power source.

Bare wire connections

CAUTION

•

These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric

shock when connecting or disconnecting the speaker cables, disconnect the power cord

before touching any uninsulated parts.

•

Make sure that all the bare speaker wire is twisted together and inserted fully into the

speaker terminal. If any of the bare speaker wire touches the back panel it may cause the

power to cut off as a safety measure.

Front speaker terminals:

Twist exposed wire strands together.

Loosen terminal and insert exposed wire.

Tighten terminal.

Center and surround speaker terminals:

Twist exposed wire strands together.

Push open the tabs and insert exposed wire.

Release the tabs.

12 3

12 mm

12 3

12 mm

LINE LEVEL

INPUT

Center

Surround right

Front right

Front leftSubwoofer

Surround left

Kaiuttimien kytkeminen

Laite toimii kahden stereokaiuttimenkin kanssa (kuvassa etukaiuttimet), mutta

suosittelemme vähintään kolmea kaiutinta, ja surroundäänelle paras vaihtoehto on täysi

asennus.

Varmista, että kytket oikeanpuoleisen kaiuttimen liitäntään R ja vasemmanpuoleisen

liitäntään L. Varmista myös, että vastaanottimen positiivinen ja negatiivinen (+/-) liitäntä

kytketään kaiuttimessa samalla tavoin.

Kaiuttimien nimellinen impedanssi saa olla 6–16 Ω.

Tee kaikki kytkennät ennen virtajohdon kytkemistä seinäpistokkeeseen.

Paljaan johdon kytkennät

Etukaiuttimien liittimet

1 Kierrä paljaaksi kuoritut

johtimet yhteen.

2 Avaa liitintä ja asenna johto.

3 Kierrä liitin kiinni.

Keski- ja surroundlaiuttimien liittimet

1 Kierrä paljaaksi kuoritut

johtimet yhteen

2 Avaa kielekkeet ja asenna johto.

3 Sulje kielekkeet.

TÄRKEÄ

• Kaiutinliitännöistä lähtee VAARALLINEN JÄNNITE. Varo sähköiskua kytkiessäsi tai

irrottaessasi kaiutinjohtoja: irrota virtajohto seinäkoskettimesta ennen eristämättömiin

osiin koskemista.

• Varmista, että paljaat kaiutinjohdon päät on kierretty yhteen ja asennettu kokonaan

liittimeen. Jos jokin paljaan johdon osa koskettaa takalevyä, virta saattaa sammua

turvatoimenpiteenä.

Etu vasenEtu oikea

Alataajuuskaiutin

Keski

Surround oikea Surround vasen

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer VSX-531D in the language / languages: Finnish as an attachment in your email.

The manual is 10,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer VSX-531D

Pioneer VSX-531D User Manual - English - 41 pages

Pioneer VSX-531D User Manual - German - 41 pages

Pioneer VSX-531D User Manual - Dutch - 41 pages

Pioneer VSX-531D User Manual - French - 41 pages

Pioneer VSX-531D User Manual - Italian - 41 pages

Pioneer VSX-531D User Manual - Spanish - 41 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Pioneer VSX-531D Manual

Product: