612931
8
Zoom out
Zoom in
Previous page
1/26
Next page
8
2.2 Switch to dual power meter mode
Both the left and right sensors are required in this mode. Cyclocomputer SGX-CA500 is required when the sensor
changes to the pedaling monitor mode. It cannot be switched by using cyclocomputers from other manufacturers.
•The firmware version of SGX-CA500 needs to be 20150501.02.43 or higher. If it is of a different version, update the
firmware. Refer to the User's Guide (For WEB) of SGX-CA500 regarding how to update.
http://pioneer-cyclesports.com/us-en/support/products/
The mode can be switched in two ways.
[Method 1] Switch by pushing the push switch in the right transmitter
[Method 2] Switch the mode on SGX-CA500
2.2.1 [Method 1] Switch by pushing the push switch in the right transmitter
When using a Cyclocomputer from another manufacturer, switch with this method.
2.2.1.1 Loosen the screws on the right transmitter cover and remove the cover.
2.2.1.2 Replacing the batteries of theleft and right transmitters.
The operation is enabled for 5 minutes after the batteries are installed. Switch within 5 minutes. If more than 5 minutes
elapse, re-install the batteries of the left and right sensors.
2.2.1.3 Confirmation of the actual sensor mode.
When the batteries are installed, the LEDs on the left and right transmitters light as follows depending on the actual
sensor mode.
When it is in pedaling monitor mode: The LEDs light green for 10 seconds
When it is in dual power meter mode: The LEDs light orange for 10 seconds
When it is in single power meter mode: The LEDs blink orange for 10 seconds
2.2.1.4 Switch the sensor mode.
Before switching the mode, confirm that there is no other
pedaling monitor nearby. If this is not done at a sufficient
distance away from other sensors, the other sensors are likely to
malfunction.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Pioneer SGY-PM910HR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Pioneer SGY-PM910HR in the language / languages: English as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Pioneer SGY-PM910HR

Pioneer SGY-PM910HR User Manual - English, German, Dutch, French, Italian, Spanish - 234 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info